TECALEMIT RAASM 37780 Use and care manual

tecalemit.com.au
37780
RAASM Digital Meter
Calibration Guide
Max Working Pressure:
70 bar (1000 PSI)
CAUTION! Read instruction manual

Digital Display
Calibration
Instruction Guide
7
8 2 3 6 4 10
1 5 9
1Partial register (5 digits with floating point) that indicates the volume delivered the
last time the RESET button was pressed
2Total register
3Indication of the multiplication factor (x10, x100, x1000)
4Indication of the type of total (TOTAL / TOTAL RESET)
5Unit of measure of partial register (Litres, Gallons, Pints, Quarts)
6Unit of measure of total register TOTAL and TOTAL RESET
7Battery icon
8Indication CAL for the calibration procedure
9Two triangles to be used for the calibrations
10 Indication of instantaneous flow rate mode (FLOW RATE)

To re-calibrate the RAASM Digital
Meter please follow the steps
outlined below.
Step 1
Ensure the digital meter display is on the
‘Stand by Screen’
Step 2
Press the ‘RESET’ and ‘TOTAL’ buttons
at the same time for 3 seconds until you
see the ‘Unit of Measure’ screen illustrated
in Step 2.
Step 1
Step 2
Calibration
Instruction Guide

Step 4
Press the ‘RESET’ until the desired number of
decimal places are displayed, then press and
hold the ‘TOTAL’ button to save and enter
the ‘Auto Reset’ screen shown.
Press the ‘RESET’ until the desired choice
for auto resetting after the display is turned
o is displayed, then press and hold the
‘TOTAL’ button to save and enter the
‘Flow Direction’ screen is shown in Step 6.
Step 3
Press the ‘RESET’ until the desired unit of
measure is displayed, then press and hold
the ‘TOTAL’ button to save and enter the
‘Decimal Places’ screen shown in Step 4.
Step 3
Step 4
Calibration
Instruction Guide

Step 6
Dispense a physically measured quantity
of oil into a graduated jug, greater than
3 Litres – 5 litres is recommended.
Press and hold the ‘TOTAL’ button to select
if the quantity of oil displayed needs to be
increased or decreased.
Press or even hold the “RESET” button to
adjust the value so it coincides with the
actual delivery quantity as shown on the
measuring jug.
Press and hold down the “TOTAL” button
to confirm and save the updated calibration
value to the memory.
Step 5
Press the ‘RESET’ until the desired choice for
Flow Direction is displayed, then press and
hold the ‘TOTAL’ button to save and enter the
‘Calibration’ screen is shown in Step 6.
Step 5
Step 6
Calibration
Instruction Guide

Tecalemit PTY Limited
2B Cardi Court Cavan,
South Australia 5094.
tecalemit.com.au
Tecalemit Pty Limited reserves the right to change specifications, modify
designs and discontinue items without incurring obligation and whilst
every eort is made to ensure that descriptions, specifications and other
information in this document are correct, no warranty is given in respect
thereof and the company shall not be liable for any error therein. All images
are for illustration purposes only.
©2020 Tecalemit Pty Limited. All Rights Reserved.
Customer Care.
Phone: [phone]
Fax: [phone]
International: [phone]
Email: [email protected]om.au