TECH FASS GSM VT-11 W34 User manual

Installation manual
V7.93 and above
CZ-9367-2
Input voltage
10 - 15 V dc
Current consumption
50 mA / 1 000 mA
Data output
Wiegand
Number of inputs
6
No of phone numbers. for SMS / dial
4/4 per each input
Simulation of telephone line
No
Service anad programming
SW VTGT, pomocí SMS
external GSM antenna
2 m
Dimensions (wxhxd)
82 x 59 x 22 mm
Design
PCB w/o housing
Module GSM VT-11 W34

Information about GSM module VT-11 W34
GSM module VT -11 W34
is equipped with Wiegand data output which resends the phone number of incomming call.
Version 7.93
 42b supported as well next to 34b wiegand format
 Last 10 numbers are taken (34, 42b) or 12 (42b only)
VT - 11 W34
 ensures the sending of the phone number of the user to the wiegand output, which is connected
to the MWGD 46 door controller or other wiegand input raeder module.
 suitable for controlling entrance gates by ringing
 32b or 42b format, other format possibility
Note
wiegand 26b format is not enough long to represent the phone number and therefore
not implemented
 users' phone numbers are not programmed into the GSM module, but only into the door units
of APS eACS (WGD 46, WGD 46.IP, MRMC 82, MREM reader modules,...)
General features
 6 inputs (when activated, they will send a programmed SMS message and / or call
up to 4 telephone set telephone numbers)
 There is no relay output on the module
 The module can detect the credit and inform the customer that the credit is running out,
send it periodically by testing message
 each input can be named
 for programming SW VT-11 is used
The phone number is in TECH FASS programms represented in hexadecimal format.
You can use standard Windows Calculator to convert the number to decimal format and back.

Wiring of GSM module to the door controller WGD 46
wiegand output format setup
use the check boxes to set the format
1 2 3 4 5 6 7 8
0 0 x x x x x x 34 bitů 10 číslic 0 604604604
1 0 x x x x x x 42 bitů 10 číslic 0 604604604
0 1 x x x x x x 42 bitů 12 číslic 420 604604604
GND
GND
IN1 IN2 IN3 IN4 IN5 IN6
D0 D1
WGD 46, channel 1
VT-11 W34
Program VT Setup v7.93 and above
34b is set as default