TechMatte amFilm GLS2 User manual
Wash and dry your hands thoroughly - this
helps to remove any oils and dirt.
Ensure that the adhesive side of the screen
protector is facing down.Carefully hold the
two tabs on either end of the screen protector.
Align the screen protector with the device.This
placement must be precise.Using the tabs,
slowly lower the glass protector onto your
device.
Once the glass is in place, gently slide your
fingertip across the screen from top to
bottom.
Clean your device’s screen - use the
included cleaning wipe to clean the entire
screen.Then use the provided microfiber
cleaning cloth to dry the screen.
Use the dust removal sticker to remove any
dust left behind. (Please SKIP this step if
applying to Nintendo Switch Products).
Pull the Step 1 Tab to remove the protective
film layer.DO NOT TOUCH THE ADHESIVE SIDE
once the protective film layer is removed.
Hold one of the two tabs and slowly peel
back the second protective plastic film.
Eliminate any bubbles by firmly pushing
bubbles off towards the edges of the glass.
Alternatively, lift the corner nearest the bubbles.
Set the corner back down and the bubbles
should be gone.
*Do not touch the screen
again after this step.
