techtron Lite 2000 User manual

Lite 2000
Instruction Manual

2
Ethos
Welcome to techtron® by combining passion, drive and
intellect with market leading research and cutting-edge
technology, we innovate and deliver premium quality
products that excite, inspire and challenge the sector.
Striving for perfection, embracing new ideas and
investing in the future is our ethos.
Future Tech. Today

3
Contents
Product and Accessories 4
Assembly 6
Charging 8
Functions 10
Smart App 12
Maintenance and Warranty 14
Rider Guidance, Safety and Specications 15

4
Product and Accessories
ABrake lever
BAccelerator
CFolding hook
DCollar clamp
EFolding pedal
FAtmosphere lights
GKickstand
H Power button
I Charge port
JMotor wheel
K Rear brake
L Reector
G
B
C
I
K
L
A
D
F
J
H
E

5
Product and Accessories
Charging adaptor x1M6 hex key x1

6
Assembly
3
Park with the
kickstand. Step on
the footboard, hold
the handlebar and
push forward to
unfold the scooter.
Insert the
standpipe into
the collar clamp.
2
Slightly loosen
the hex bolts
on the collar
clamp with the
M6 hex key
1

7
Assembly
Tighten the bolts on
the collar clamp with
the M6 hex key.
4
5
If the brake is too tight or loose,
you can thread in/out the brake
cable adjuster.

8
Charging
To charge the techtron® eScooter, simply open the rubber stopper on the side of the
footboard and connect the power supply. Then plug in the power supply and switch
on the power. Please allow three hours for the eScooter’s battery to fully charge.
When the eScooter’s battery is fully charged, the charge indicator on the plug will
change from red to green. After charging, please ensure you replace the stopper
to prevent water damage.
Children should be supervised at all times and should not touch the device
whilst charging.

9
Charging

10
Functions
Factory default settings
Riding mode Maximum speed Power light
Turbo 14km/h Fast blinking
Cruise 7km/h Slow blinking
Accelerating and decelerating
Action Cruise mode Turbo mode
Accelerate Kick o to go, then press the accelerator
Decelerate Use front/rear brakes Release accelerator or use front/rear brake
Power button
To power the eScooter ON/OFF, press and hold the main power button located
on the side of the footboard for two seconds.
The atmosphere lights along the side of the scooter can also be controlled with
a single press of the power button.
Riding modes
The techtron® Lite 2000 comes with two factory default riding modes: Turbo and
Cruise. These can be determined by the power light status, detailed in the table
below. In Cruise mode the scooter will hold it’s speed without the need for the
accelerator to be pressed. With Turbo mode activated the scooter will gradually
slow and stop if the accelerator is released.
For added safety, the techtron® smart app can be used to limit each speed mode,
in order to best suit your child’s age or ability. As they further advance their riding
skills the scooter’s speed can then be increased to the Lite 2000 model’s actual
maximum: 18km/h.

11
Functions
Power saving
The eScooter will power down
automatically after three
minutes when not in use.
Product registration
For exclusive oers, product
support and information on the
latest techtron® innovations,
register your product by
completing the form on the
website with your serial number
and details - www.techtron.co
Charge status
Green 100% - 51%
Yellow 50% - 21%
Red 20% - 1%
Battery indicator
The power button displays current charge
status (see table below). When an error occurs,
the battery/mode indicator will ash and an
alarm will sound.

12
techtron® Smart App
Download to your smart device via
the Apple App Store or Google Play.
Light: OFF
Settings
Turbo modeConnection
0.0
km/h
t-802358
Trip Info
71%
Settings
Unit: Metric
Riding mode
Cruise mode speed limit value 7Km/h
Cruise mode
2
1
Your eScooter can be congured using the techtron® smart app.
Use it to set up your desired settings such as riding mode and speed limiter.
You can even lock the scooter to prevent unauthorised access.
Please note - the eScooter will remember all settings applied
in the techtron® smart app even when Bluetooth® is disconnected.
Google Play Apple App Store

13
techtron® Smart App
Trip Info
Remaining range 8.5Km
Mileage for this journey 1.5Km
Total mileage 13.6Km
Scooter temperature 12.8˚C
Total driving time 0H 18M 42S
Current speed 18Km/h
Current 1.0A
Voltage 24V
Power 130W
Error code 0
Warning code 0
Electronic control version 80.7.1 (00030251)
Bluetooth version 6.9.3 (03)
App Version 1.1.0
Firmware upgrade
3
App store is a service mark of Apple Inc.
Android and the ‘Google Play’ logo are trademarks of Google Inc.
Home screen
View the remaining range of your
eScooter, so you can plan your journey.
Lights - Turn the atmosphere lights
On/O.
Settings - Access further controls.
Connection - Discover and pair your
eScooter to your smart device.
Riding mode - Toggle between riding
modes.
Trip info - View the latest trip information.
Settings
Unit - Change the unit of measurement
used to display your speed from km/h
to mph.
Riding mode - Choose your preferred
riding mode.
Cruise/Turbo mode speed limit - Control
how fast the scooter can go if being used
by children.
Trip info
View your eScooter’s latest trip
information, anything from total driving
time to voltage and power statistics.
The device rmware can also be
upgraded by the user from this menu
(internet connection required).
3
2
1

14
Maintenance and Warranty
This marking indicates that this product should not be disposed
with other household wastes throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device, please use the return
and collection systems or contact the retailer where the product was
purchased. They can take this product for environment safe recycling.
All product images shown in this instruction manual are for illustrative purposes only and may dier
slightly from the actual product.
Cleaning and storage
Use a soft cloth dipped in a small amount of water to wipe the eScooter; for any dicult
to clean areas, you can use toothpaste and gently brush with a toothbrush, then use a
damp cloth to clean.
Do not use alcohol, petrol, kerosene, or other corrosive, volatile chemical cleaning
solvents, as this will seriously damage the appearance and internal structure of the
body. Do not use pressure washers to clean. Ensure that the charging cable has been
unplugged and the rubber stopper on the charging port is closed. Otherwise, there may
be a chance of electric shock or serious failure due to internal water intake.
Warranty policy
techtron® oers a one-year guarantee on rechargeable batteries. Two-year guarantee
against parts and/or manufacturing defects, Terms & Conditions/Exclusions apply,
please see website for further details.
Product registration
For exclusive oers, product support and information on the latest techtron®
innovations, register your product by completing the form on the website with your serial
number and details - www.techtron.co
Battery maintenance and disposal
Do not touch the battery contacts, and do not open or expose the shell. Avoid metal
objects touching the battery contacts, as this will cause a short circuit, damage to the
battery, or even personal injury.
Please refer to the model specications in this manual for your eScooter’s charging
requirements. Only use a charger with the correct voltage otherwise there will be a risk
of damage to components or re.
Ensure batteries are disposed of responsibly. Recharge the battery and store it after
use, to preserve battery life. Do not place the battery in high temperatures higher than
50°C or below -20°C, or it may lead to battery failure, overheating, or even risk of re.
Always store in a cool dry place fully charged. A battery will be at optimum performance
at a standard room temperature. Warranty may be invalid if the battery is removed.
Children should be supervised at all times.

15
Rider Guidance, Safety and Specifications
Model Lite 2000
Range 10km
Power 130W
Top Speed 18 km/h
Speed Modes 2
Hill Incline 7%
Rider Age 6-15 yrs
Max. Load 20-50kg
Battery 24V 2.55Ah
Charger 25.2V/1A
Storage Temp -20˚C to 50˚C
Working Temp -10˚C to 40˚C
Rider Height 115cm - 145cm
Frame Material Aluminium
Current Limit 5A
Motor Type Brushless DC
IP Rating IPX4
Foldable Yes
Tyre Size Front: 6.5”, back: 6”
Model specications
Any enquiries regarding
maintenance, accessories, security
or warranty, please visit the techtron
website:
www.techtron.co
or email us:
[email protected]
Rules of the road and licensing guidance
For the latest up-to-date safety, licensing guidance and rules of the road for UK eScooter
users, please consult the UK Government website:
www.gov.uk/guidance/e-scooter-trials-guidance-for-users
Helmets and clothing
Wearing cycle helmets are recommended when
riding an eScooter, but they are not a legal
requirement. Always make sure that your cycle
helmet conforms to current regulations, is the
correct size, and is securely fastened. Wear light-
coloured or uorescent clothing so that other road
users can see you at night or whenever visibility
is poor.
As with any vehicle, the faster the user is travelling,
the more braking distance is required. Please
respect pedestrians’ right of way when riding
the techtron® eScooter.
Riding safely
Please check the eScooter before riding.
Check for loose parts and general tyre wear
and tear.
Always start the eScooter by pushing o with your
foot rst, this reduces the start load on the motor,
ensuring a longer battery life.
The techtron® eScooter is designed to perform
best on smooth dry surfaces, therefore avoid riding
on uneven gravel, sand, grass, slick or wet surfaces.
Never ride over curbs or jump. The eScooter is not
designed for this type of riding and any damage
caused to the eScooter while riding in this manner
will void the warranty.
techtron® accepts no liability for any injuries caused
to rider or damage to property which may arise
while riding the eScooter. Never ride the scooter
with more than one person, as this may lead to loss
of control. It is the rider’s responsibility to ensure
they comply with all local laws and regulations that
may apply while riding the eScooter.

For further information and advice you can find us at:
techtron® Unit 2, Jowett St,
Bradford, BD1 2JX. UK.
e: [email protected]
t: 0203 307 6776
w: techtron.co
Research & Development 2100 Geng Road, Suite 210,
Palo Alto, California, 94303 USA.
e: [e-mail] w: techtroncalifornia.com
techtron® is a division of Multibrands International Ltd.