Moma Ebike 20 User manual

USER’S MANUAL
USER’S MANUAL
OF ELECTRIC BIKES
OF ELECTRIC BIKES

User’s manual – E Bikes
Momabikes –All rights reserved
INDEX
1.
IMPORTANT INFORMATION
2. DEFINITIONS
3.
BIKE’S UNPACKING
4.
GENERAL INFORMATION
5. BATTERY
6. DISPLAY
6.1 Ebike 20
6.2 Ebike26 / Eb
ike28 /
7. TECHNICAL SPE
CIFIC
8.
PROBLEM’S SOLUTION
9. WARRANTY
IMPORTANT INFORMATION
BIKE’S UNPACKING
, INSTALLATION, SETTINGS AND
MANTE
GENERAL INFORMATION
ike28 /
E-MTB
CIFIC
ATIONS
PROBLEM’S SOLUTION
Page2
MANTE
NANCE

User’s manual – E Bikes
Momabikes –All rights reserved
1.
IMPORTANT INFORMATION
PEDALS: The pedals of the bike you have just received have a L and a R at the
extremity of the axis. The pedal with the R spins clockwise
right side; the pedal with the L spins the other way around (anti
DERAILLEUR: This bike requires a 20 hours running
only using the medium speed and the central cassette during this t
or lower speeds during this running
ring.
BRAKES: The disc brakes also need a 20 hours running
they won’t be working 100% and there might be some friction
this phase. We recommend not to make any kind of adjustments because all the
components sent come a little tensed up to avoid readjustments just after the running
phase.
CHARGE
DURING 12H BEFORE TH
FIRST USE.
DO NOT LET
DOWN.
We recommend charging
use the b
ike, a
down completely.
completely run down
be powerful
enough to recover the battery
IMPORTANT INFORMATION
PEDALS: The pedals of the bike you have just received have a L and a R at the
extremity of the axis. The pedal with the R spins clockwise
and has to be set up on the
right side; the pedal with the L spins the other way around (anti
-
clockwise).
DERAILLEUR: This bike requires a 20 hours running
-in phase.
You have to make it by
only using the medium speed and the central cassette during this t
ime. If you use higher
or lower speeds during this running
-
in phase the bike chain may come out of the chain
BRAKES: The disc brakes also need a 20 hours running
-in phase.
At the beginning
they won’t be working 100% and there might be some friction
s that will go away during
this phase. We recommend not to make any kind of adjustments because all the
components sent come a little tensed up to avoid readjustments just after the running
DURING 12H BEFORE TH
DO NOT LET
TH
E BATTERY RUN
We recommend charging
it every t
ike, a
nd never let the battery run
down completely.
In case the battery would
completely run down
, the charger
may not
enough to recover the battery
Page3
PEDALS: The pedals of the bike you have just received have a L and a R at the
and has to be set up on the
clockwise).
You have to make it by
ime. If you use higher
in phase the bike chain may come out of the chain
At the beginning
s that will go away during
this phase. We recommend not to make any kind of adjustments because all the
components sent come a little tensed up to avoid readjustments just after the running
-in
DURING 12H BEFORE TH
E
E BATTERY RUN
it every t
ime you
nd never let the battery run
In case the battery would
may not
enough to recover the battery
.

User’s manual – E Bikes
Momabikes –All rights reserved
2. DEFINITIONS
Page4

User’s manual – E Bikes
Momabikes –All rights reserved
3.
BIKE’S UNPACKING, INSTALLATION, SETTINGS AND
MANTENANCE
Refer to
the corresponding section in the
www.momabikes.com.
BIKE’S UNPACKING, INSTALLATION, SETTINGS AND
the corresponding section in the
User’s Manual of ordinary bikes,available
Page5
BIKE’S UNPACKING, INSTALLATION, SETTINGS AND
User’s Manual of ordinary bikes,available
at

User’s manual – E Bikes
Momabikes –All rights reserved
4.
GENERAL INFORMATION
We recommend not using
the Bike under the rain, particularly under
The electronic components,
drownedin water.
To connect
the motor, you have to turn the
turn on the
display of the handle stem.
It is pos
sible to ride the bike with the pedaling assistant mode on or only with the
accelerator (only Ebike20
, Ebike26
-
With the pedaling assistant mode on, you just have to pedal in order to
the motor. The level of the
-
If you wish, you can ride the Bik
in consideration that
significantly
, whether it
latter.
Brakes d
isconnect the motor: when you activate
will be automatically disconnected.
hands owing
to the fact that a light pressure could stop the motor.
Some of the components s
by professionaltechnicians
GENERAL INFORMATION
the Bike under the rain, particularly under
driving
The electronic components,
such as the motor, battery, controller
the motor, you have to turn the
key of the battery on the
“ON” position and
display of the handle stem.
sible to ride the bike with the pedaling assistant mode on or only with the
, Ebike26
and Ebike28; E-
MTB do not have accelerator)
With the pedaling assistant mode on, you just have to pedal in order to
the motor. The level of the
assistance
is controlled from the display.
If you wish, you can ride the Bik
e only with the accelerator. But you must take
in consideration that
the autonomy of the bike’
s battery will decrease
, whether it
isto maintain the speed
or to start up, particularly for the
isconnect the motor: when you activate
one of the two brake lever
will be automatically disconnected.
You must try not to
press the brake levers with your
to the fact that a light pressure could stop the motor.
uch as the battery, motor or controller
, must be manipulated
only.
Page6
driving
rain.
such as the motor, battery, controller
, must not be
“ON” position and
sible to ride the bike with the pedaling assistant mode on or only with the
MTB do not have accelerator)
With the pedaling assistant mode on, you just have to pedal in order to
connect
is controlled from the display.
e only with the accelerator. But you must take
s battery will decrease
or to start up, particularly for the
one of the two brake lever
s, the motor
press the brake levers with your
, must be manipulated

User’s manual – E Bikes
Momabikes –All rights reserved
5. BATTERY
Before the first use, make sure the battery is fully
In or
der to optimize the battery’s life, you should always leave it fully loaded, and load
it once a month if you do not use the Bike.
To charge
the battery, first connect
power grid.
The red light of the charger will turn on, which indicates the battery is
charging
. When the battery is fully
You always have to disconnect the battery from
want to disconnect
the charger, do it firstly from
from the battery.
Charge
the battery during 12h before the first use.
The 3 following charges
must be continu
Never leave the charger connected to the
VERYIMPORTANT
CHARGE
THE BATTERY DURING 1
BEFORE TH
E
DO NOT LET THE BATTE
DOWN.
We recommend
use the b
ike, and
down completely.
entirely
, the charger may not be powerful
enough to
recover the battery.
Before the first use, make sure the battery is fully
charged.
der to optimize the battery’s life, you should always leave it fully loaded, and load
it once a month if you do not use the Bike.
the battery, first connect
the
plug to the battery; secondly, connect it
The red light of the charger will turn on, which indicates the battery is
. When the battery is fully
charged, the red light will turn g
reen.
You always have to disconnect the battery from
the power gridafter
charging
the charger, do it firstly from
the
electricity network and
the battery during 12h before the first use.
must be continu
ous and last 12h too.
Never leave the charger connected to the
power grid
when it is not used.
VERYIMPORTANT
:
THE BATTERY DURING 1
E
FIRST USE.
DO NOT LET THE BATTE
RY RUN
We recommend
charging
it every time
ike, and
to never let the battery run
down completely.
In case
it would run down
, the charger may not be powerful
recover the battery.
Page7
der to optimize the battery’s life, you should always leave it fully loaded, and load
plug to the battery; secondly, connect it
to the
The red light of the charger will turn on, which indicates the battery is
reen.
charging
. When you
electricity network and
secondly
when it is not used.
THE BATTERY DURING 1
2H
RY RUN
it every time
you
to never let the battery run
it would run down
, the charger may not be powerful

User’s manual – E Bikes
Momabikes –All rights reserved
6. DISPLAY
6.1 Ebike 20
Buttons:
-
Power: switch on/off the engine
-
Lights: switch on/off lights of the bike
-
Mode: select level of assistance to pedaling
Indicators:
-Lights:
shows if the lights of the bike are switch on or off
-
Level de battery: shows charge’s level of the battery
-
Assistance to pedaling: shows assistance’s level of the engine.
o
Low: Lower assistance/help to pedals
o
High: Highest assistance/help to pedals
Power: switch on/off the engine
Lights: switch on/off lights of the bike
Mode: select level of assistance to pedaling
shows if the lights of the bike are switch on or off
Level de battery: shows charge’s level of the battery
Assistance to pedaling: shows assistance’s level of the engine.
Low: Lower assistance/help to pedals
High: Highest assistance/help to pedals
Page8

User’s manual – E Bikes
Momabikes –All rights reserved
6.2 Ebike 26 /
Ebike28
Buttons:
-
Power: press once to switch on the engine. Once connected, press to switch
on/off the lights of the bike. If you want to disconnect the bike hold some
seconds.
-
Up/down: select the level of assistance to pedaling.
oUp: fo
r a mayor assistance/help of the engine.
o
Down: for a minor assistance to the engine.
Indicators:
-
Lights: shows if the lights of the bikes are on. If the lights are off, that icon
doesn`t appear on the display.
-
Level of the battery: shows the level char
-
Assistance to pedaling: shows the level of assistance in which the engine is. A
higher level more help during pedaling.
Ebike28
/ E-MTB
Power: press once to switch on the engine. Once connected, press to switch
on/off the lights of the bike. If you want to disconnect the bike hold some
Up/down: select the level of assistance to pedaling.
r a mayor assistance/help of the engine.
Down: for a minor assistance to the engine.
Lights: shows if the lights of the bikes are on. If the lights are off, that icon
doesn`t appear on the display.
Level of the battery: shows the level char
ge’s level of the battery
Assistance to pedaling: shows the level of assistance in which the engine is. A
higher level more help during pedaling.
Page9
Power: press once to switch on the engine. Once connected, press to switch
on/off the lights of the bike. If you want to disconnect the bike hold some
Lights: shows if the lights of the bikes are on. If the lights are off, that icon
ge’s level of the battery
Assistance to pedaling: shows the level of assistance in which the engine is. A

User’s manual – E Bikes
Momabikes –All rights reserved
7.
THECNICAL SPECIFICATIONS
Maximum speed
Net weight (Ebike26 / Ebike20
Maximum autonomy
Maximum charge weight
Distance between axes
(Ebike26 / Ebike20 / E-
MTB
Dimensions
(Ebike 26 / Ebike 20 / E-
MTB
Noise during the operation
Waste of energy every 100km
Type of battery cells
Battery’s capacity
Battery’s voltage
Minimum security voltage
Overcharge security current
Engine type
Engine nominal power
Engine nominal voltage
* The ebikes’
autonomy refers to an adult standard weight of 70kg on a totally flat
ground used in the assistance to pedaling mode. Less you help the bike, lower will
be the autonomy. In the same way the autonomy decrease considerably, going uphill
and if increase the
weight of the cyclist.
THECNICAL SPECIFICATIONS
25km/h
Net weight (Ebike26 / Ebike20
/ E-MTB) 20 / 18 / 20 kg
80km *
120kg
MTB
)
116 / 108 / 112 cm
MTB
)
182x62x110 / 162x61x116
177x63x107 cm
<60db
Waste of energy every 100km
<1.2kW/h
Ion Lithium
16Ah
36V
31,5V
Overcharge security current
16A
Motor Brushless
250W
36V
autonomy refers to an adult standard weight of 70kg on a totally flat
ground used in the assistance to pedaling mode. Less you help the bike, lower will
be the autonomy. In the same way the autonomy decrease considerably, going uphill
weight of the cyclist.
Page10
182x62x110 / 162x61x116
/
autonomy refers to an adult standard weight of 70kg on a totally flat
ground used in the assistance to pedaling mode. Less you help the bike, lower will
be the autonomy. In the same way the autonomy decrease considerably, going uphill