
The LCD screen shows "Timer"
...... THIS IS THE PROGRAMMING MODE
3. To set the time for the coffee machine to start automatically, press the "Time"
key to set hour and press Min. To set the minutes.
4. After setting the program, press the "PROG" key to confirm the command.
The green LED lights up.
The green light will remain lit until the coffee maker will turn on.
When the set time is reached, the green light goes off and the red light comes on,
meaning that the coffee maker has started.
You have 8 seconds to cancel the start by pressing one of the keys. If no button is
pressed, the coffee will pass through the filter into the carafe.
5. After the coffee has flowed, the jug will hold the hot coffee for 30 minutes.
After this time it will turn off automatically.
NOTE: To re-schedule another time, press twice on "clock" to display "timer"
again, the indicator lights up green and you can :
Either reset the unit to a new starting time.
Either press "prog" again to cancel programming.
To re-program the start-up of the coffee maker, refer to the paragraph:
AUTOMATIC PROGRAMMING.
USING THE COFFEE MAKER WITHOUT PROGRAMMING
1. Open the tank / filter cover.
2. Fill the water tank with clear water to the required number of cups of coffee.
3. Place a paper filter (or permanent filter not included) in the holder filter.
4. Place the coffee powder in the filter.
5. Close the lid.
6. Press the "M / A" button to start the coffee maker.
7. After the coffee has flowed, the jug will hold the hot coffee for 40 minutes.
After this time it will turn off automatically.
Note: If it is not necessary to keep the coffee warm, press "M / A" again and the
appliance will stop working.
CLEANING AND MAINTENANCE
Before cleaning, always switch off the appliance, disconnect the apparatus and let
it cool.
Clean the outside of the apparatus with a sponge or slightly wet linen.
The parts (removable) in contact with food like plate, bowl, forks, Spatula etc. can
be washed in hot water with sponge and soft detergent or put in the dishwasher.
Never plunge the apparatus in water or all other liquid !
Do not use abrasive cleaners, gritting, or metal brush or another cutting object.
If the area of use is very “limestone", it is strongly advised to get rid of the
limestone every two months.