tecnotelai E369 User manual

E36
Via Bonazzi, 4 - 40013 Castel Maggiore (BO)
Tel. [phone] (10 linee) - Fax [phone]
[email protected] - www.tecnotelai.it
!/!1 2
!
3
Lightly tighten the screws with the supplied key passing
through the outer hole in the side.
Engage the sides in the screws passing them through the eyelets.
2
Partially tighten 4 screws in the bottom.
1
WORKSHOP DETACHABLE CABINETS
installation instructions
Art.E369
Art.E371
INSTALLATION OF CABINETS
4
Snap the ceiling on the sides and tighten the 4 screws loosely.
5
Fit one back at a time in the rear part with the folds outwards and
secure with plastic tacks (first insert the largest part in the hole and
then lock with the tack inside using a hammer).
Cielo
Bottom
Side
Back
Press to lock

E36
Via Bonazzi, 4 - 40013 Castel Maggiore (BO)
Tel. [phone] (10 linee) - Fax [phone]
[email protected] - www.tecnotelai.it
!/!2 2
If there is a partition wall, insert the flaps of the rear part between
the 2 backs and fix as explained in step "5".
6
Fully tighten all screws.
7
Make sure that the floor is perfectly level and, in case of slight
unevenness, shim the cabinet.
8
Position the left door at the centre, with the bearings on top, and
twist to lock it in position in the most internal guide rail of the
ceiling. Verticalize the door to insert it into the base groove. Repeat
with the right door that is inserted in the outermost guides.
9
Lock the doors with 4 pressure inserts into the dedicated slots.
10
Engage the lock in the hole of the right door and secure it from the
inside with the clip. Check that the lock is working perfectly.
11
Partition wall
(only for
cabinets of width
1500-1800)
part to be
engaged
between the
backs