TecnoVideo 129 Series User manual

Air barrier
for 129 Series Camera Housings
Installation manual
Issue 20150206

DESCRIPTION
The air barrier is designed to protect front flange of 129 Series camera housings from the formation of dust and
other deposits. With the air barrier is recommend the use of optional filter ABFL- 1 to clean the air coming usually
from a compressor.
MODE S
129ABIR70 Camera housing (L=36 mm) with front window air barrier. Sunshield and heater optional. UFW: 7 mm
129ABIR70- Camera housing (L=46 mm) with front window air barrier. Sunshield and heater optional. UFW: 7 mm
UFW: Usable front window diameter
i
Prior to installation and operation, read carefully all instructions the in this manual and heed all warnings.
Unpack this equipment and handle it carefully. If the package appears to be damaged, notify the shipper
immediately.
Use the original packaging to transport the unit. Disconnect power supply before moving it. In case of returning the
equipment, the original packaging must be used.
Use caution when lifting and assembling the unit. It is recommended that non-slip protective gloves be worn
during installation. The unit could bear sharp edges.
TECHNICA DATA
Air inlet through 1/8” GAS threaded hole
Included super-rapid fitting (inlet Ø 6)
Dimensions: Ø136x2 mm
Weight 1kg
Max inlet air pressure 3 bar
2

DIMENSIONS
FRONTA VIEW SIDE VIEW
Dimensions in millimetres – Tolerances according QMS – Design and product specifications subject to change without notice
3

Preserve this manual as a reference for future needs. Here you can find the always up-to-date pdf ersion of this document:
Used electrical, electronic and stainless steel products should not be mixed with general waste.
For proper treatment, recovery and recycling of old products, please take them to applicable collection points, in accordance with your national
legislation and the Directives 2 2/95/EC and 2 2/96/EC.
By disposing of these products correctly, you will help to save valuable resources and prevent any potential negative effects on human health
and the environment which could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products, please contact your local municipality or your waste disposal service.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
The manufacturer declines all liability for any consequence resulting from improper installation practices, tampering or improper uses of the
product.
The descriptions and illustrations contained in this manual are not binding. The manufacturer reserves the right to make any alterations deemed
appropriate for the technical, manufacturing and commercial improvement of the product, while leaving the essential product features
unchanged, at any time and without undertaking to update the present publication.
TECNOVIDEO S.r.l.
Via San L. Murialdo, 8 36 3 Villaverla (VI) ITALY
Tel. [phone] Fax [phone]
e-mail: [e-mail] – www.tecnovideocctv.com
15540 Rockfield Blvd, Suite C-110
Irvine, CA 92618
Phone: [phone]
Fax: [phone]
Email: [email protected]
http://www.movitherm.com
Your authorized TECNOVIDEO distributor: