TeddyPardo DBX Venue 360 Conversion Kit Troubleshooting guide

Teddy Pardo DBX Venue 360 Conversion Kit
Quick Startup Guide
Teddypardo.com/dbx360
inf[email protected]m

•Step 1: Remove the power cord. Remove the
top cover, using a Philips screwdriver for the
side and back screws, and an allen key (Torx
#20 also works) for the front panel screws.
Remove top screws using Allen key (or Torx #20)

•Step 2: remove the 3 screws
holding the power supply in place.
Remove the ground wire and the
main power plugs.

•Step 3: using a flat screwdriver,
push the power socket clips and
push out the power entry socket.

•Step 4: Repeat step 3 at the
bottom side, remove the power
entry socket.

•Step 5: Cut the power supply
wires, cut the fan wires.

•Step 6: use a sharp knife and
tweezers to remove the heat shrink
from the power connector. Use a
soldering iron to remove the
remaining wires from the
connector.

•Step 7: place the panel adapter,
place the 3mm screws.

•Step 8: place the panel adapter
fasteners, place the 3mm bolts.
Note: do not over-tighten the
screws!

•Step 9: Place the power
connector, secure the cable with a
cable tie.

•Product assembly is completed,
replace the top cover.

•Attach the power supply cable
and power on to verify operation.
Replace the top cover, installation is
now completed.