TeddyPardo TeddySB3 User manual

www.teddypardo.com

TeddySB3/TeddyDuet/TTouch/
TeddyEvo/RDAC-PS/Zodiac-PS/
YoungDAC-PS
Power Supplies
Owner’s manual
www.teddypardo.com

Owner’s Manual - Power supplies
Introduction
The TeddySB3/TeddyDuet/TTouch power supply family was designed to power Logitech audio
streamers. They replace the original Logitech SMPS power supply.
Please follow your Logitech product owner’s manual for the corresponding connection instructions.
Mains Power
The power supply should be connected to the mains via a standard cable with an IEC plug. For safety
reasons it is preferable to use cables with molded plugs. The power supply should be connected to a
grounded mains socket.
Fuses
The power supply is equipped with a fuse that resides in a small drawer on the IEC socket situated
on the rear panel. Use only “slow blow” fuse for replacement.
Use the following table to select the appropriate fuse value:
Power supply
220-240V
110-120V
TeddySB3
315-400mA
680-1000mA
TeddyDuet
315-400mA
680-1000mA
TTouch
315-400mA
680-1000mA
TeddyEvo
315-400mA
680-1000mA
RDacPS
315-400mA
680-1000mA
ZodiacPS
315-400mA
680-1000mA
Switching On
In order to switch on and off your power supply use the power switch situated on the rear panel.
Best performance will be achieved when leaving the system switched on for long periods. Power
consumption of the power supplies is in the order of few tens of Watts. The green LED indicates
POWER ON.
Cables
In order to keep the connectors clean it is recommended to disconnected and reconnect the plugs
several times every 3-4 months. This operation will clean oxidation and dirt from the plugs and
sockets.
Always switch off your power supply before connecting or disconnecting cables.

Burn in
The power supply requires a burn-in period of at least one week, during the first month the sound
will continue to improve gradually. Note also that the internal capacitors need about 30 minutes
until they are fully charged and perform optimally.
Specifications
Product
TeddySB3
TeddyDuet
TTouch
Outputs
5V 1.5A
9V 500mA
5V 3A
Dimensions
(H x W x D, mm)
57 x 169 x 243
Mains
110-120V or 220-240V, 50/60Hz
Conformity
Manufacturer
Teddy Pardo, Hod Hasharon Israel
Products
TeddyCap, TeddyCapPlus, DualTeddyCap, TeddyXPS
Safety
EN 60065