TeddyPardo TeddyCAP User manual

www.teddypardo.com

TeddyCAP, TeddySuperCap,
TeddyXPS
Power Supplies
Owner’s manual
www.teddypardo.com

Owner’s Manual - Power supplies
Introduction
The TeddyCap power supply family was designed to power Naim Audio pre amplifiers, CD players,
headphone amplifiers, active crossovers, phono stages, etc. They replace the original products: HiCap,
FlatCap, SuperCap and XPS.
Please follow your Naim Audio product owner’s manual for the corresponding connection diagram.
Note that according to the Naim Audio schema, power amplifiers should be connected to the power
supply rather than to the pre amplifier. Failing to do so may damage the power supply and/or the
power amplifier.
Mains Power
The power supply should be connected to the mains via a standard cable with an IEC plug. For safety
reasons it is preferable to use cables with molded plugs. The power supply should be connected to a
grounded mains socket.
Fuses
The power supply is equipped with a fuse that resides in a small drawer on the IEC socket situated on
the rear panel. Use only “slow blow” fuse for replacement.
Use the following table to select the appropriate fuse value:
Power supply
220-240V
110-120V
TeddyCap
315-400mA
680-1000mA
TeddyCapPlus
315-400mA
680-1000mA
DualTeddyCap
400-680mA
800-1000mA
TeddyXPS
800-1000mA
1600-2000mA
TeddySuperCap
400-680mA
800-1000mA
Switching On
In order to switch on and off your power supply use the power switch situated on the rear panel. Best
performance will be achieved when leaving the system switched on for long periods. Power
consumption of the power supplies is in the order of few tens of Watts. The green LED indicates
POWER ON.

Cables
The cables which are supplies with the power supply are not directional. It is however a good practice
not to change the cable direction once installed and burned-in.
In order to keep the connectors clean it is recommended to disconnected and reconnect the plugs
several times every 3-4 months. This operation will clean oxidation and dirt from the plugs and sockets.
Always switch off your power supply before connecting or disconnecting cables.
Burn in
The power supply requires a burn-in period of at least one week, during the first month the sound will
continue to improve gradually. Note also that the internal capacitors need about 30 minutes until they
are fully charged and perform optimally.
Specifications
Product
TeddyCap
TeddyCapPlus
DualTeddyCap
TeddyXPS
Outputs
2 x 24V 300mA
2 x 24V 300mA
18V 300mA
2 x 24V 300mA
2 x 24V 300mA
18V 300mA
±22V 300mA
±10V 300mA
2 x 15V 1A
Dimensions
(H x W x D, mm)
57 x 169 x 243
Mains
110-120V or 220-240V, 50/60Hz
Conformity
Manufacturer
Teddy Pardo, Hod Hasharon Israel
Products
TeddyCap, TeddyCapPlus, DualTeddyCap, TeddyXPS, TeddySuperCap
Safety
EN 60065