Tekvox Podium TCX10 User manual

www.tekvox.com
TCX10 - Podium
78042
-
10A Installation Guide
Included in this Product Package:
Step 1: Select Location for TCX10
TCX10 mounting location should be conveniently &
easily accessible. TCX10 should not be directly in front
of or behind any other equipment. Allow at least 4” on
either side of mounting wedge. Do not mount TCX10
directly over any structural members of the furniture.
Step 2: Drill Hole for Cable Pass-Through
If drilling additional holes in furniture is prohibited, skip this step and proceed with
installation, following directions for over-table cable routing. In desired TCX10 location,
lightly sketch a 3 ¾” square for locating the mounting wedge. In the center of this square,
drill a ¾” dia. hole for the TCX10 cable.
Step 3: Attach Mounting Wedge to Surface
If using over-table cable routing:
Route cable through cutout on back of mounting
wedge. Run cable out through rectangular opening in
mounting wedge, with at least 6” of slack.
All Installations
Using the four (4) included #6 wood screws, attach the
mounting wedge to the table in its intended location.
Ensure that screws are snug, but do not overtighten, as
this can cause the threads to tear through the surface
and lose holding power.
Security
Bracket
TCX10 Touchscreen
Controller
Mounting
Wedge
#6 Wood
Screws (4)
6-32 Machine
Screws (4)
Device Plate
DO NOT OVERTIGHTEN SCREWS

www.tekvox.com
TCX10 - Podium
78042
-
10A Installation Guide
Step 4: Attach the Device Plate to the Mounting Wedge
Using two (2) of the provided black 6-32 screws, attach the
TCX10 device plate to the front of the mounting wedge. Use the
upper set of holes on the front face of the mounting wedge.
Tighten screws until snug, but do not overtighten, as this can
cause warping of the device plate. Ensure that device plate is
level and centered before tightening screws fully.
Step 5: Route Cable up Through Mounting Wedge
If using cable passthrough hole (Step 2):
Route cable from underneath table surface through hole drilled in Step 2. Run
cable out through rectangular opening in mounting wedge, with at least 6” of
slack.
Step 6: Connect & Mount TCX10
Connect provided Category cable to the TCX10 port labelled “POE.” If cable is
connected to second port, device will not power on. Before mounting, ensure
that other end of the cable is connected to a PoE-capable network. Wait for
the TCX10 to power on, and confirm that it has a network connection.
Gently push TCX10 towards mounting wedge, ensuring that
the cable does not get pinched, kinked, or bent too sharply.
Align three (3) indentations on back of TCX10 with
mounting tabs on the device plate. Once, aligned, push
TCX10 towards mounting plate to seat tabs, then press
down to lock into place. Check that all tabs are properly
seated into their mounting slots.
Step 7: Attach Security Bracket
Using two (2) remaining black 6-32 screws, attach the TCX10 security bracket
to the top of the mounting wedge. Security bracket should fit snugly over the
top of the TCX10, but should not obscure any portion of the screen. Tighten
screws fully.
The TCX10 Touchscreen Controller is now fully installed. To remove for any reason, simply
reverse steps 5-7.
≥ 6”