TELETECH TSA7000 4G User manual
TSA7000 4G 2 TeleTech
Package Content
•TSA7000 4G
•Power Supply
•Power cord
•Microphone
•Power plug adapter
•14-pin screw terminal
•Rubber tule
Technical information
Dimensions
H: 41 mm x W: 147 mm x L: 105 mm
Weight
507 g
IP rating
IP20
Antenna
SMA (female)
Temperature rating
0 C- +50 C
Battery
3 x 3,2 V LiFePO4 18650
Supply voltage
100-240 V AC, 50-60 Hz, max.: 4 A
Installation
Placement
TSA7000 4G is designed to be mounted on top of the elevator car. It’s recommended to
place on top or close to a ventilation hole to optimize sound travelling to the cabin. The in-
cluded microphone is placed in another ventilation hole apart from the speaker or in a
panel in the cabin using the rubber tule included. Place the TSA7000 on a plane surface,
thoroughly cleaned for any metal shards.
Mounting
The two flanges can be used for screw mounting the TSA7000 4G, if needed.
TSA7000 4G 3 TeleTech
Quick start
1. Install the microphone
2. Connect the emergency cabin button to 5 og 6 of the green 14-pin screw terminal
3. If necessary, connect yellow pictogram in 11, green in 12 and emergency light in
13. Pin 14 is common ground
4. Plug the green 14-pin screw terminal in to the TSA7000 4G
5. Connect the power to the TSA7000, It is important that this is first done after the
green 14-pin screw terminal is connected, as the TSA7000 first action is to see
whatever the connected cabin button is NO or NC.
6. Yellow LED lights on. Then green LED will blink and when connected to the net-
work and ready the green LED stops blinking and stays on.
7. Configure ID, phone numbers and protocols for call center using TeletechBlue App
8. Test and check for successful routine call and emergency call
Signal strength
Signal strength is shown in % on the TeletechBlue app.
Power off
Turn off TSA7000 4G by disconnecting from the power supply and then pressing the ser-
vice button in the front by 5 seconds.
Yellow pictogram
Emergency light 12V DC
+
+
Green pictogram
+
Emergency cabin button (NO/NC)
TSA7000 4G 4 TeleTech
LED indicators
Configuration
Configuration is done in the TeletechBlue app using Bluetooth
TeletechBlue can be download in the Apple App Store and Google Play Store
If there is set an access password on the TSA7000, it is possible to go in to configuration
mode from within the cabin, so it is possible to adjust the mic and speaker volume during a
test call to optimize the sound experience.
The alarm is booting up
The alarm is searching for network connection
The Alarm is online and ready
The Alarm is in Bluetooth parring mode –push the servicebutton
The Alarm is connected to the TeletechBlue app and ready for programming
The Alarm is preforms data transmission (rutinecall/emergency call)
The Alarm is running on Battery backup. (No 220V power connected)
TSA7000 4G 5 TeleTech
ABP TeleTech A/S
Københavnsvej 261A –4000 Roskilde
Table of contents
Other TELETECH Test Equipment manuals
