Tellur TLL161141 User manual

Hypnos 2.1 Bluetooth
Soundbar System
TLL161141

User Manual
Safety information
Important - Please read these instructions carefully
before installing or operating the device.
Power source
Only use the power supply that came with the
product. Using an unauthorized power supply will
invalidate your warranty and may irrecoverably
damage the product.
Disconnect your Soundbar from the main power
supply during thunderstorms.
If the Soundbar will not be used for a long period of
time, make sure that the main power is unplugged
and the batteries are removed from the remote
control battery compartment.
The supply terminals are not to be short-circuited.
Never throw batteries in a fire or attempt to open the
outer casing.
Batteries are harmful if swallowed, so keep away
from young children.
CAUTION: Danger of explosion if batteries are
incorrectly replaced. Replace only with the same or
equivalent type.
Moisture and water
Do not keep the product in low temperatures as
moisture can form inside the product, which may
damage the circuit board.

Heat sources and flames
Do not keep it in high temperatures as electronic
devices and plastic parts may warp in heat.
Keep it away from bright sunlight or heat sources,
such as a radiator.
No naked flame sources, such as lighted candles,
should be placed on the product.
Ventilation
Do not block or cover slots, holes or openings on the
product by placing on soft furnishings such as
carpets, rugs or beds as these are provided for
functionality and/or ventilation to ensure safe
operation of the product.
General safety information
Keep the product and all its parts out of reach of
small children.
This product is not intended for use by people
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning the use of the appliance by
a person responsible for their safety.
Do not attempt to open the product. This product
does not contain any user serviceable parts.
Unauthorized handling of the device may damage it
and will void your warranty.
• Do not use your Soundbar near
emergency/intensive care medical equipment or
during an electrical storm.
Product description
Main Unit
1. Press and hold: power on/standby
2. Change the mode (Bluetooth/AUX in)
3. Press and release: Play/Pause
Press and hold: Unpair a BT device
4. Press and hold: Volume down
Press and release: Skip back
5. Press and hold: Volume up
Press and release: Skip forward
6. Mode LED (Blue for BT, Green for AUX in)
7. AUX in socket
8. DC socket
Note: If no source is played, the unit will enter
standby mode automatically after about 20
minutes.

Subwoofer
9. Clam ports
Note: Please insert the
speaker cable (included)
into the clam ports by the
anode and the cathode.
Power ON/OFF / Bluetooth®set up:
Place the speaker next to your Bluetooth® enabled
device.
Press and hold the Power button. You will hear a tone
notification and the blue LED will flash quickly to
indicate pairing mode.
Using your Bluetooth audio device, select “Tellur
Hypnos” from the list of available Bluetooth devices.
A tone notification will be heard and the blue LED will
flash slowly to indicate pairing was successful.
Press and hold the Power button to turn off the
speaker.
Remote Control
1. Power on/Standby
2. Change the mode (Bluetooth/AUX in)
3. Skip back
4. Play/Pause
5. Skip forward
6. Unpair a Bluetooth device
7. Change the EQ settings
09
8. Mute/Unmute the sound
9. Volume down
10. Volume up
11. Install the remote batteries
Technical Information
• Speaker type: 2.1
• BT version: 4.2
• Working range: 10 meters
• Remote control: Yes
• Rated power: 48W RMS (12W x 2 + 24W)
• Frequency response: 65Hz - 20KHz
• Drivers size: 3" x 2 + 5" x 1
• Impedance: 4Ω
• Signal to Noise ratio (SNR): ≥78dB
• Power supply: AC 220V-240V - 50/60Hz to
DC 15V - 2A
• Device size: Soundbar 50 cm x 11.2 cm x 5.4 cm
Subwoofer 38.7 cm x 36.7 cm x 9.5 cm

• Device weight: Soundbar 1.1 Kg
Subwoofer 3.9 Kg
• Package includes: Hypnos Wireless 2.1 Soundbar
System, AC/DC adapter, AUX 3.5mm audio cable,
Remote control, AAA battery x 2
Disposal and recycling information
The crossed-out wheeled-bin symbol on your product,
battery, literature or packaging reminds you that all
electronic products and batteries must be taken to separate
waste collection points at the end of their working lives; they
must not be disposed of in the normal waste stream with
household garbage. It is the responsibility of the user to
dispose of the equipment using a designated collection point
or service for separate recycling of electrical and electronic
equipment waste (WEEE) and batteries according to local
laws. Proper collection and recycling of your equipment helps
ensure EEE waste is recycled in a manner that conserves
valuable materials and protects human health and the
environment. Improper handling, accidental breakage,
damage, and/or improper recycling at the end of its life may
be harmful for health and environment.
Declaration of conformity
We, ABN SYSTEMS INTERNATIONAL S.R.L., Bucharest,
Sector 1, Marinarilor street, nr. 31, we declare on own
responsibility that the products below:
Product description: Soundbar system Tellur Hypnos, Subwoofer, 48W
Brand: Tellur
Product code: TLL161141
Does not endanger life, health, work safety, does not have a
negative impact on the environment and corresponds to the
standards stated in the manufacturer's declaration of
conformity. The products are compliant with the following
standards and / or other normative documents:
RED – 2014/53/EU
Applied standards: ETSI EN 301 489-1 V2.2.0:2017
ETSI EN 301 489-17 V3.2.0:2017
ETSI EN 300 328 V2.1.1:2016
EN 62479:2010
EN 300 328 V2.1.1: 2016-11
EN 303 345 V1.1.7: 2017-03
LVD – 2014/35/EU – EN 60065:2014
RoHS – 2011/65/EU
The product bears CE mark, applied in 2018
Name: George Barbu Place and date:
Function: General manager Bucharest, 07-12-2018
Signed: