Tenergy 59012 User manual

Packing Contents:
1x 360 Degree Rotating Stand Case with Bluetooth Keyboard For iPad Mini
1x USB Charging Cable (to charge the keyboard)
1x User manual
1. Caps Lock indicator
2. Bluetooth indicator
3. Charging indicator
4. Power indicator
5. Bluetooth connecting
button
6. Power on/off switch

Pairing the iPad Mini with the Bluetooth keyboard:
Step 1: Make sure your iPad is turned on.
Step 2: Toggle the power switch to the ON position on the right side of keyboard. The power light will be
on for a second.
Step 3: Wait a few seconds before pressing the connect button on your keyboard. Once you press the
connect button, the Bluetooth light will flash, then the keyboard is ready to pairing.
Step 4: Click the Settings button on your iPad. Select General, then Bluetooth.
Step 5: The iPad will search for your keyboard. Select “Bluetooth Keyboard” on the iPad screen.
Step 6: A message prompt will appear on your iPad screen. The prompt will provide you with a unique
passkey to authorize the pairing of your iPad and Bluetooth keyboard. Enter the passkey exactly as it
appears on the screen, then press the enter key on your keyboard. Your keyboard is now synched with
your iPad device. If the passkey is entered incorrectly, the devices will not pair. You will have to repeat last
Steps and re-enter the passkey through the Bluetooth menu on your iPad.

Charging the bluetooth keyboard:
When the power light begins flashing continuously, there is approximately one hour of battery life
remaining. It’s time to charge your keyboard.
Your keyboard charges via a USB port located on the right side of your keyboard next to the power switch.
Use the provided USB cord, attaching the small end to your keyboard and the larger end to any USB port
for charging. A red indicator light will appear to confirm that the unit is charging. When the red indicator
turns off, charging is complete.
Troubleshooting and Tips:
If you are unable to sync the Bluetooth keyboard to the iPad, please try the steps below:
1. Make sure your iPad is turned on and working properly. Make sure your keyboard is turned on.
2. Press and release the connect button on the top right of the Bluetooth keyboard. The light will flash.
3. Make sure that your iPad is within effective range of the keyboard.
If the recommendations above do not solve the sync issue, reboot both your iPad and keyboard and try
again. Follow the sync steps again. Please note that it may take up to some seconds for a new passkey to
be generated.
TIP: When your battery is low, the power light on the keyboard will blink. You should charge your
keyboard immediately.
Storage:
To prolong battery life, always switch the power on the keyboard to OFF after each use.
Keyboard Specification
1. Bluetooth 3.0 interface
2. Operating Distance range to 10 meters
3. Operating Voltage: 3.0-5.0V
4. Working Current: <4.0mA
5. Standby Current: 2.5mA
6. Sleeping Current: <200μA
7. Charging Current: about 100mA
8. Standby Time: 60 days
9. Charging Time: 3-4hours
10. Lithium Battery Capacity: 350mA
11. Continuous Working Time: About 70 hours
12. Key Strength: 80±10g
13. Key Life: 5 million strokes
14. Operation Temperature: -10℃to 65℃