Tenn-Tex Plastics QuikTRAY Rollout System User manual

Installation Instructions
for faceframe cabinets
Instrucciones de Instalación
www.quiktray.com
www.tenntex.com
Made in USA
1d
1e
1c
1a
1b
Pilaster
Qty: 4
Bumper
Qty: 2
Drawer Slide
Qty: 2L/2R
Hook
Dowel
Hook
Dowel
Qty: 8
Hook
Dowel
Screw
Hook
Dowel
Screw
Qty: 8
#6x1/2”
Screw
Qty: 40
#6x1/2”
Screw
Qty: 5 per
pilaster
Additional tools needed:
Screwdriver, pliers
For additional installation questions, call 1-800-TENNTEX
between the hours of 9am and 4pm EST
Drawer
connector
Qty: 4
Drawer
box
Qty: 2
Hook
Dowel
Hook
Dowel
Hook
Dowel
Screw
Hook
Dowel
Screw
With Half Shelf
Without Half Shelf
90°
HOOK DOWEL
ASSEMBLY
Mount the hook
dowels so the
lip points up
Use the pilaster
to hold the hook
dowel at 90°
when tightening.
Angle the slide to
get the lip into the
hole in the pilaster.
FRONT PILASTER
INSTALLATION
2
Place QuikTRAY™ pilaster
behind face-frame.
Rest pilaster against
cabinet bottom.
Fasten with 5 screws.
INS-QT01

BACK PILASTER INSTALLATION
With Half-Shelf Without Half-Shelf
4 4
3 3
DRAWER BOX
ASSEMBLY
ATTACH
DRAWER SLIDE
5
6
7
8
Install on the
hinge side on
the front.
#6x1/2” Screw
Qty: 2 per
connector
Front
Front
#6x1/2” Screw
Qty: 1 per
bumper
Insert two drawer slides
to top and bottom of
unattached rear pilaster.
Insert two drawer slides
to top and bottom of
unattached rear pilaster.
Insert front
hook dowels
into front
pilaster.
Insert front hook
dowels into
front pilaster.
Float rear
pilaster into
position and
fasten with
screws.
Float rear
pilaster into
position and
fasten with
screws.
The hook on the back of the
slide fits into the hole on the
back of the drawer box.
Set the drawer
box on the slides
and push back
to engage the
connectors.
The front of the
drawer is plain, the
back has cutouts
and hols for the
slides to hook into.