TerraWave Solutions T35160P1000665 User manual

www.terrawave.com Email: [e-mail] Phone: [phone] or 800-851-4965 10521 Gulfdale, San Antonio, TX 78216
TerraWave Solutions®3.5 GHz 16 dBi Sector Panel Antenna
with 65-Degree Horizontal Beamwidth and N-Style Jack Connector
TerraWave’s 3300-3800 MHz 16 dBi 65-degree sector panel antenna is designed for outdoor WiMAX network
applications. This antenna features high gain in a slim profile and is constructed of UV resistant PVC. The
antenna is easy to install and includes an articulating mast mount and integrated N-Style Jack connector. All
TerraWave antennas are covered by the Company’s two-year TerraNet warranty program. For questions and to
purchase product, contact a wireless networking solutions sales engineer at 210-375-8482, 800-851-4965 or
[email protected]. Visit www.terrawave.com for additional information.
E-Plane H-Plane Pattern
Specifications
Model Number T35160P1000665
Frequency Range 3300 - 3800 MHz
Bandwidth 500 MHz
Gain 16 dBi
Polarization Vertical
Electrical Downtilt 0°
Half-power Beamwidth Horizontal: 65° / Vertical:10°
Front-to-Back Ratio ≥25 dB
VSWR ≤1.5
Impedance 50 Ω
Intermodular Distortion (2x43 dBm Carrier) ≤-150 dBc
Maximum Input Power 100 Watts
Lightning Protection DC Grounded
Connector N-Style Jack (female)
Connector Position Bottom of Antenna
Dimensions 19.69" (H) x 4.49" (W) x 2.13" (D)
Antenna Weight with Installation Kit 4.4 lbs
Wind Loading Area 0.07 Ft²
Rated Wind Velocity 134.2 mph
Reflector Material Aluminum Alloy
Radome Material UV PVC
Radome Color Pantone Cool Gray
Mechanical Tilt 0-10°
Operating Temperature Range -40° F - +140° F
Mounting Hardware 1.18" x 2.76"

TerraWave Solutions®3.5 GHz 16 dBi Sector Panel Antenna
with 65-Degree Horizontal Beamwidth and N-Style Jack Connector
Installation Information for T35160P1000665
www.terrawave.com Email: [e-mail] Phone: [phone] or 800-851-4965 10521 Gulfdale, San Antonio, TX 78216
I. Tools Required: Two 13 mm Box Wrench
II. Installation Diagram:
Pole
Mounting
Assembly
Clamp
Bolt
III. Installation Instructions:
A. Remove the bolts, nuts and washers from the clamp. Push clamp against either side of the pole and
insert bolts. Replace the washers and nuts and tighten.
B. Adjust the angle of the antenna and then tighten the clamps on the pole.
C. Remove the protective cover on the antenna connector and attach cabling. Weatherproofing tape may be
used.
Notes:
- Ensure the antenna is installed in a safe and suitable location and well away from high power lines.
- Do not attempt to install during inclement weather.
- Do not attempt to install the antenna on a pole with a diameter other than 1”-3”.
Antenna