TerraWave Solutions T24100Y13602 User manual

TerraWave Solutions®2.4 GHz 10 dBi Yagi Antenna with RPTNC Plug Connector
TerraWave’s 2.4 GHz yagi antenna is a rugged, high performance directional antenna to be used as
a bridge antenna between two networks or for point-to-point communications. The antenna provides
10 dBi of gain and a very symmetrical pattern characteristic. It may be installed in either vertical or
horizontal polarization. Includes an RPTNC plug with a 36” pigtail and a mast mount. Every
TerraWave antenna is covered by the Company’s two-year TerraNet warranty program. Visit
www.terrawave.com for additional information.
Specifications
Model T24100Y13602
Frequency Range 2400 - 2483 MHz
Bandwidth 83 MHz
Gain 10 dBi
Vertical Beamwidth 48°
Horizontal Beamwidth 48°
VSWR -/=1.5
Nominal Impedance 50 Ohms
Polarization Vertical or Horizontal
Max Power 100 Watts
Connector RPTNC Plug with Pigtail
Dimension 14” x 2” x 2”
Weight 2 lbs
Rated Wind Velocity 135 mph
Operating Temperature Range -22°F to +158°F
Front-to-back Ratio +/=18 dB
E-Plane Pattern H-Plane Pattern
10521 Gulfdale, San Antonio, TX 78216 www.terrawave.com www.tessco.com/go/terrawave Phone: [phone] Email: [e-mail]

TerraWave Solutions®2.4 GHz 10 dBi Yagi Antenna
Mounting Bracket Information for T24100Y13602, T24135Y13602 and T24150Y13602
Installation Instructions:
• By default, the antenna is in vertical polarization mode.
• For horizontal polarization installation, unscrew the antenna from the L-bracket
and rotate 90 degrees. Screw the antenna back to the L-bracket. Be certain
that the polarization arrow is parallel to the ground when installed.
• Mount the antenna to the mast with the U-bolt and hex nuts.
• Adjust the antenna angle until the signal reception is optimized.
• Fasten all screws.
Note: Mast mount diameter: ≤2”
10521 Gulfdale, San Antonio, TX 78216 www.terrawave.com www.tessco.com/go/terrawave Phone: [phone] Email: [e-mail]