
4
Assembly
BEFORE BEGINNING THE ASSEMBLY
When selecting a place to assembly this product, favor those places that are external and covered,
sheltered from wind, humidity and direct sunlight. Selecting a good place for this product, will
ensure that it will keep its original look for a longer period.
The product must necessarily be set over a flat surface, rigid and level. If the base surface does
not meet the conditions required, the assembly will be deficient and upset the look and structural
integrity.
For the assembly, the use of mortars with high resistance cement and quick dry cement is not
allowed, e.g. white cement, aluminium cement or similar, refractory cement, or cement mortar for
laying ceramics. You must use a mortar with 20% low resistance cement and 80% fine sand. As an
alternative you may use a fire-resistant silicon with high temperature resistance. Use of silicon will
ensure a better finish in the joints, especially in those models that do not require finishing or painting
(plan series, plan fold, ego and kitaway).
The product must be installed to allow the dilation/contraction typical for this type of product,
otherwise there could be fissures. Use a very thin layer of bricklayer’s mortar or silicon to ensure the
natural dilation between the components.
MAINTENANCE
To clean the product, use only water and a cloth or abrasive sponge, “scotch brite” type. The
concrete components can also be cleaned occasionally with water and a nylon hairbrush. When you
clean the concrete components with water, remove all the other components of metal so that they
do not become we
Durability of this product will depend upon good practices of use and maintenance.
We also inform you that a few accessories for the use and maintenance of your product are
available.
Inquire at the shop where you acquired this product or consult our website www.fccproducts.no.