The Land of Nod Low-Rider Bookcase User manual

Made in Vietnam - r06 Page 1 of 4
ASSEMBLY HARDWARE
COMPONENTS
TOOLS REQUIRED
Thank you for purchasing the Low-Rider Bookcase.
This page lists all the contents included in the box. Please
take the time to identify the hardware as well as the
individual components to this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
Customer Service 800.933.9904 | Latest instructions available on www.landofnod.com
phillips head screwdriver
(We recommend the use of hand tools instead of power tools)
12 - flat
washers
22 - small
screws
12 - spring
washers
6 - large
bolts
12 - wood
dowels
6 - small
bolts
1 - base
assembly
1 - back
panel 1 - top
panel
1 - partition 2 - side panels
(1 left, 1 right)
4 - shelf
supports
2 - adjustable
shelves
Missing hardware? Please call 800.933.9904 for replacements.
NOTE: Contains small parts. Keep away from small children.
WARNING: Adult Assembly Required
!
q
p
l
ik
nmo
a d c
fe
b
LOW-RIDER
BOOKCASE

LOW-RIDER
BOOKCASE
Made in Vietnam - r06 Page 2 of 4
Customer Service 800.933.9904 | Latest instructions available at www.landofnod.com
3
1 2
Insert 4 wood dowels (a) into left side panel (m)
and right side panel (o) as shown.
Insert 4 wood dowels (a) into partition (n) as
shown.
Fit dowels of left side panel (m), right side panel
(o), and partition (n) into corresponding holes of top
panel. Loosely attach with 2 short bolts (c), 2
spring washers (f) and 2 flat washers (e) per panel
as shown.
left side
panel
partition
NOTE: Do not
fully tighten the
bolts
df
c
e
4
With the assistance of another adult, fit dowels
assembled unit into corresponding holes of base
assembly (p). Loosely attach with 6 large bolts
(d),6spring washers (f) and 6 flat washers (e) as
shown.
NOTE: Do not
fully tighten the
bolts
m
right side
panel
o
n
m
o
n
i
a
a
base
assembly
p
m
n
o
e
f
d

Made in Vietnam - r06 Page 3 of 4
Customer Service 800.933.9904 | Latest instructions available at www.landofnod.com
Attach back panel (q) to assembled unit with 22
small screws (b), using a phillips head
screwdriver. At this point, fully tighten all bolts
with a screwdriver.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
unit is finished with a protective clear lacquer
5
With the assistance of another adult, position unit
upright. Insert 4 shelf supports (k) into assembled
unit at desired shelf heights. Fit adjustable shelves
(l) onto corresponding notches of each shelf
support. Adjust levelers as necessary to level the
bookcase. Assembly is now complete.
NOTE: Make sure
notches on shelf
supports are facing
each other
adjustable
shelf
shelf
support
6
q
l
k
b
LOW-RIDER
BOOKCASE

For added safety and stability, it is recommended that the wall mounting hardware be installed. For safe mounting, it is
essential to use wall anchors appropriate to your wall type (i.e. plaster, drywall, concrete, etc.). Mount to wood studs
whenever possible.
A) Attach mounting bracket to top of unit using 2 small screws.
B) Determine the final location of unit. Mark position on the wall, approximately 2" below the mounting bracket mounted to
the back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not available, drill a hole in the wall that is slightly smaller in diameter than
the anchor. Gently tap the plastic anchor until the flange of the anchor is flush with the wall.
D) Attach the mounting bracket to the wall by inserting 2 large screws through the mounting bracket and into the wall
anchor in the wall.
E) Place the unit so the mounting bracket on the back edge is allowed with the wall bracket.
F) Lace one end of the wall strap through both brackets, and into the other end of the strap.
G) Pull the strap tightly until secure.
Repeat step A-G for remaining wall mounting assembly.
NOTE: If you are unsure about your wall type or what mounting method you should use, consult a qualified
professional.
Wall mounting assembly is now complete.
LOW-RIDER
BOOKCASE
Made in Vietnam - r06 Page 4 of 4
Customer Service 800.933.9904 | Latest instructions available at www.landofnod.com
A
C
D
small
screw
mounting
bracket
plastic
anchor
large
screw
wall
strap
mounting
bracket
Serious or fatal crushing injuries can occur from furniture
tip over. Use of tip-over restraints may only reduce, but
not eliminate, the risk of tip-over. To help prevent tip-over,
install tip restraint per instructions below.
WARNING
!
4 - small
screws
4 - large
screws
4 - plastic
anchors
4 - mounting
brackets
Missing hardware? Please call 800.933.9904
for replacements. NOTE: Contains small
parts. Keep away from small children.
MOUNTING HARDWARE
2 - wall straps
TOOLS REQUIRED
WALL MOUNTING ASSEMBLY
power drill
(for pilot holes only)
phillips head screwdriver
WALL