The Land of Nod Storage Cube Bench User manual

The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Storage Cube Bench (Corner Unit) Assembly Instructions
Page 1 of 5
Made in China - r05
This page lists the contents included in the box. Please take
time to identify the hardware as well as the individual
components of the product. As you unpack and prepare for
assembly, place the contents on a carpeted or padded area
to protect them from damage. Please follow the assembly
instructions closely. Improper assembly can result in
personal or property damage.
Note: 2 adults are required to safely assemble this product.
not includedx 01 x 01 x 01
x 01 x 01
x 01 x 01
WARNING:
CHOKING HAZARD - SMALL PARTS
Small parts present in unassembled state.
Adult assembly required.
x 20 x 08 x 04
x 08 x 08 x 02 x 04
not included

1
2
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Storage Cube Bench (Corner Unit) Assembly Instructions
Page 2 of 5
Made in China - r05

3
4
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Storage Cube Bench (Corner Unit) Assembly Instructions
Page 3 of 5
Made in China - r05

CLEANINGANDCARE:
Cleansurfaceswithadryordampsoftcloth.Donotuseabrasivecleaners. Periodically check and tighten hardware as necessary.
5
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Storage Cube Bench (Corner Unit) Assembly Instructions
Page 4 of 5
Made in China - r05

MULTIPLE BENCH UNIT ASSEMBLY 
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Storage Cube Bench (Corner Unit) Assembly Instructions
Page 5 of 5
Made in China - r05
Configuration #2Configuration #1
B B
A A
Align bracket with pilot holes and secure
each bracket with 2 screws as shonw,
using a Phillips head screwdriver. Repeat
steps for remaining units.
Using a hammer, firmly tap screws into
marked positions to create pilot holes.
Arrange corner and bench units into
desired configuration shown above.
Position 2 brackets onto 2 units. Using a
pencil, mark the bracket holes and set
brackets aside.
Note: Please note that mending plates are recommended and should be attached to
the underside of the top panels. However, mending plates are optional and can be
used at customer discretion.
Configuration #4 Configuration #5Configuration #3
A: Single Unit (sold separately)
B. Corner Unit
A A
BB
AA
A A
A
B
AAA A AAA A