The Land of Nod Topside Crib User manual

- Failure to follow these warnings and assembly instructions could result in serious injury or death.
- Read all instructions before assembling crib. Keep instructions for future use.
-Infants can suffocate on soft bedding. Never add a pillow or comforter. Never place additional padding
under an infant.
-To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to sleep, unless
otherwise advised by your physician.
Strangulation Hazard:
- Strings can cause strangulation! DO NOT place items with a string, cord or ribbon around a child’s neck,
such as hood strings or pacifier cords. DO NOT suspend strings over crib or toddler bed, or attach strings to
toys for any reason.
-To help prevent strangulation, tighten all fasteners. A child can trap parts of the body or clothing on loose
fasteners.
- DO NOT place crib or toddler bed near windows where cords from blinds or drapes may strangle a child.
Fall Hazard:
- When child is able to pull to standing position, set mattress to lowest position and remove bumper pads,
large toys and other objects that could serve as steps for climbing out.
-When child is able to climb out or reaches the height of 35 inches (90 cm), the crib shall no longer be used
and the child should be placed in a youth or regular bed.
CAUTION: ANY MATTRESS USED IN THIS CRIB
MUST BE AT LEAST 27-1/4 INCHES (69 cm) BY 51-5/8
INCHES (131 cm) WITH A THICKNESS NOT EXCEEDING
6 INCHES (15 cm).
- Check this product for damaged hardware, loose joints, missing pats or sharp edges before and after
assembly and frequently during use. Securely tighten loose bolts and other fasteners. DO NOT use crib if any
parts are missing, damaged, or broken. Contact The Land of Nod® for replacement parts and instructional
literature if needed. DO NOT substitute parts.
- If refinishing, use a non-toxic finish specified for children’s products.
- Never use plastic shipping bags or other plastic film as mattress covers because they can cause suffocation.
- Infants can suffocate in gaps between crib sides and a mattress that is too small.
- Periodically check to see that all bolts are securely tightened.
- To clean crib: Wipe with clean soft cloth dampened with a mild cleanser and water. Rinse with clean water
using a soft cloth, and dry thoroughly.
- Follow warnings on all products in a crib.
- When a vaporizer is in use, always aim vapor steam away from the crib as well as away from other wood
furniture.
WARNING:
!
!
WARNING:
!
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Topside Crib Assembly Instructions
Made in China - r04

1 - Allen wrench 1 - Small Allen wrench
Note: Two Allen wrenches have been provided for flexibility in assembly.
Both wrenches will work with all fasteners used.
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Topside Crib Assembly Instructions
Page 1 of 8
Made in China - r04
This page lists the contents included in the box. Please take
time to identify the hardware as well as the individual
components of the product. As you unpack and prepare for
assembly, place the contents on a carpeted or padded area
to protect them from damage. Please follow the assembly
instructions closely. Improper assembly can result in
personal or property damage.
Note: 2 adults are required to safely assemble this product.
18 - Lock
washers
WARNING:
CHOKING HAZARD - SMALL PARTS
Small parts present in unassembled state.
Adult assembly required.
4 - Wood
dowels
2 - Left
brackets
2 - Right
brackets
8 - Bracket bolts
4 - Small bolts
16 - Screws
8 - Large bolts
6 - Medium bolts
1 - Phillips head screwdriver
NOT INCLUDED

The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Topside Crib Assembly Instructions
Page 2 of 8
Made in China - r04
1 - Front panel 1 - Back panel 1 - Mattress support panel
1 - Left panel 1 - Right panel 1 - Bottom panel
1 - Left drawer base 1 - Middle drawer base 1 - Right drawer base
2 - Drawer fronts 4 - Drawer sides
(2 left, 2 right)
2 - Drawer backs 2 - Drawer bottoms

1
2Insert 2 wood dowels into left and right side panels as shown. Fit dowels of side panels into corresponding holes of
back panel. Secure back panel with 4 large bolts and 4 lock washers, using an small Allen wrench.
Attach 2 left brackets and 2 right brackets to mattress support panel with 2 bracket bolts per bracket as shown.
Secure, but do not over tighten, bolts with an Allen wrench.
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Topside Crib Assembly Instructions
Page 3 of 8
Made in China - r04

3
4Fit pre-assembled dowels of left, middle and right drawer base into corresponding holes of back panel as shown.
Make sure the lettered label on each drawer base corresponds with the label on the back panel during assembly.
Determine desired height (low, middle, high) for the crib mattress. Attach left and right brackets of mattress support
panel to assembly with 4 small bolts and 4 lock washers, and secure with an Allen wrench.
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Topside Crib Assembly Instructions
Page 4 of 8
Made in China - r04
high
middle
low
E
E
NOTE: Make sure
drawer glides are
facing front during
assembly

5
6
Insert bottom panel into assembly as shown. Make sure bottom panel sits above the cleat on the back panel.
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Topside Crib Assembly Instructions
Page 5 of 8
Made in China - r04
Slide front panel into assembly as shown. Fit pre-assembled dowels of left, middle and right drawer base into corre-
sponding holes of front panel. Make sure bottom panel sits above the cleat on the front panel.

7
8Using an Allen wrench, secure left, middle and right drawer bases to assembly with 6 medium bolts and 6 lock
washers as shown.
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Topside Crib Assembly Instructions
Page 6 of 8
Made in China - r04
Secure front panel to assembly with 4 large bolts and 4 lock washers as shown.

9
10
Locate 4 levelers to bottom of side panels as shown. At this point, carefully position unit upright and adjust levelers as
necessary.
Attach left drawer side to drawer front and drawer back with 4 screws. Make sure the lettered labels on each drawer
side correspond with the drawer front and back. Secure, but do not over tighten, screws with a Phillips head screw-
driver. Insert drawer bottom into corresponding slots of drawer assembly as shown. Attach right drawer side to
drawer assembly with 4 screws. Repeat steps for remaning drawer.
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Topside Crib Assembly Instructions
Page 7 of 8
Made in China - r04
NOTE: Make sure
drawer glides are
facing back during
assembly

11 Carefully insert each drawer into assembly as shown. Assembly is now complete.
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Topside Crib Assembly Instructions
Page 8 of 8
Made in China - r04
CLEANINGANDCARE:
Cleansurfaceswithadryordampsoftcloth.Donotuseabrasivecleaners. Periodically check and tighten hardware as necessary.
Once the crib is in use, periodically check to make sure all bolts are tight, and tighten as necessary. Keep these
instructions for future use.
MAINTENANCE
Upon completion of assembly, be sure all screws, bolts and fastening devices have been tightened securely.
Periodically repeat this check to make sure all screws, bolts and fastening devices are tight. Before each usage or
assembly, inspect crib for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use crib if parts
are missing or broken. DO NOT substitute parts. DO NOT make any alteration to this crib.
CLEANING
Mix together a mild solution of gentle dishwashing liquid and water, apply to crib surface using a soft clean cloth
lightly dampened in the solution. Rinse with clean water again using a soft clean cloth, then dry all surfaces
thoroughly with a soft dry cloth. NO ABRASIVE CLEANERS, SCOURING PADS, STEEL WOOL OR COARSE RAGS
SHOULD BE USED TO CLEAN THIS FINE FURNITURE.
STORAGE
After completing the assembly process you are advised to read and beware of all WARNINGS, CAUTIONS,
CLEANING, STORAGE, USE AND MAINTENANCE notices contained in these instructions. For long term storage of
the crib, store in a cool, dry place and keep away from moisture and extreme temperature changes.