The Singing Machine Classic iSM990BT User manual

iSM990BT
Bluetooth

PAIRING button

BLUETOOTH

BLUETOOTH
BLUETOOTH SETUP
1.) Power on the unit by pressing the ON/OFF button.
2.) Press the FUNCTION button to switch to Bluetooth mode. The display will show the flashing letters “bt”.
3.) “ bt “ will flash quickly on the display.
When pairing, remain within 3 feet of the unit.
If the unit does not automatically begin to pair, press
and hold the PAIRING button.
4.) Using the native controls on your Bluetooth device, select
the “Singing machine” in your Bluetooth settings to pair.
If your device requests a password, enter the default
password “0000”.
Refer to the user’s manual for your specific device for
instructions on pairing and connecting Bluetooth device.
5.) When successfully paired, the display will stop flashing.
After initial pairing, the unit will stay paired unless unpaired manually by the user or erased due to a
reset of the devices.
If your device should become unpaired, follow the above steps again.
If any pairing issues should occur, un-pair the unit on your Bluetooth device and follow the above
steps again.

PLAYING MUSIC VIA BLUETOOTH
1.) Follow the instructions for Pairing a Bluetooth Device.
2.) Use the native controls on the connected Bluetooth Device to select a track.
3.) To play, pause or skip the selected track, use the native controls on the connected Bluetooth Device or
press the PLAY/PAUSE, SKIP button of unit.
4.) Audio played through the connected Bluetooth device now be heard through the speaker.

No sound when playing
audio via Bluetooth
Your Bluetooth device has been
paired properly.
The volume control of your
Bluetooth device is set at too
low.
The volume control of the
Bluetooth speaker is set at too
low.
Pairing your Bluetooth device
according to the " PAIRING YOUR
BLUETOOTH DEVICE" section.
Increase the volume of your Bluetooth
device.
Increase the volume of the unit by tune
the volume knob to "+".

BLUETOOTH SECTION
SUPPORT A2DP / AVRCP
2.5A