TheMagicTouch HTP123 User manual

WARNING! - CAUTION!
Note: This device must be operated by one
professional operator only! Keep hands
clear from moving parts! Hot surface!
Don't touch Heater during operation!
Remove from power supply for all
maintenance and servicing
to avoid electrical
shock!
Operator Manual
HTP123 HeatPress
Copyright TheMagicTouch, Germany 2018
Specifications
Dimensions, open (L x W X H)
63 x 41 x 86 cm
Printable Area
38 x 38 cm / 15” x 15”
Weight 36 kg
Voltage 110-120/220-240 V
Amperage 120V - 16A / 240V - 8A
Maximum Wattage 1800 W
Environmental Conditions 10-40°C / 50-105 , 30-70% RH°F
Temperature Range 80°C / 176°F to 220°C / 430°F
Timer Range 0-999 Seconds
Warranty 10 Years on HeatPlaten / 1 Year Parts
Controller
LCD Display
Handle
Power
Switch
Power
Socket
Circuit
Breaker
Pressure
Knob
Counter Range 0-999
Machine Legend

Copyright TheMagicTouch, Germany 2018
Control Panel Legend
LCD Display Set Temperature when lit
Up/+ Button
Down/- Button
Mode Selection Button
Set Time when lit Set Counter when lit
Controller Assembly
1. Insert Controller between
the Frame
2. Insert and tighten the
Hand Screws 3. Attach Heat Platen
Cable and tighten
the Screw Ring
Attach the Power Cable and switch the machine on. The Controller LCD should illuminate.
Adjusting Temperature, Time, Counter and Pressure
Press Set Button > ‘Set Temp’ will be lit > Select Temperature with the Up or Down Button >
Press Set Button again > ‘Set Time’ will be lit > Select Time with the Up or Down Button >
Press Set Button again > ‘Counter’ will be lit > Use the Down Button to re-set Counter to 1.
Press the Set Button again to return to StandBy/Idle. If you don’t need to make changes
just press the Set Button again to skip the Mode. At the end all Mode Indicators must be off
to return to StandBy/Idle.
To adjust the Pressure turn Pressure Knob clockwise to increase the pressure and counter-
clockwise to decrease. High pressure would be the point where you just still can close and
lock the press.
Warm-up when moving
C/F Temperature Range Indicator

Copyright TheMagicTouch, Germany 2018
Switch between C and F Temperature Calibration
Press the Set and the Up Button together
and hold for 3 Seconds to switch between
the C and F temperature range. The selected
will be shown by the C/F Temp Indicator.
Press the Set and the Down Button together
for 3 Seconds to enter the Calibration Mode.
“Calibrate” will be lit. Use Up or Down Button
to adjust the Value. Press Set button to quit.
Explosion View and Parts List

Copyright TheMagicTouch, Germany 2018
In case of Operating Trouble please contact your local TheMagicTouch Office, Distributor or
Dealer or TheMagicTouch GmbH, Germany at [phone].
www.themagictouch.com
Electrical Schematic 110-120V
Electrical Schematic 220-240V