Thermasol MUD RING User manual

IMPORTANT! READ INSTALLATION AND PRODUCT GUIDE P/N 81127
STEP 2
OPTIONAL MODES
SILICONE (INCLUDED)
ThermaSol Steam Bath Co. 1958 Steam Way, Round Rock, TX 78665
Toll-free: 800.776.0711 Fax: [phone]
Visit us online @ www.thermasol.com
81132R Rev B 10/14 JWJ
Once desired fit is achieved coat back
of control face with supplied silicone.
Firmly press to wall surface and wipe
excess silicone from around control.
Tape into LEVEL position and allow
24 hours to completely dry.
i
Once finished tile is completed remove mud ring from
wall. Ensure that a total minimum depth is 5/8” so control
face sits flush to wall. Connect cable so it is not lost in
wall. Test fit for flushness.
STEP 3
BEFORE TILE -Using the supplied mud ring
attach to wall face using a few standard
screws. Then tile to the edge of mud ring.
MUD RING INSTALLATION
***FOR RECESSED MODERN CONTROLS ONLY***
P/N SEMR-XX (XX- DENOTES FINISH)
STEP 1
IMPORTANT NOTE:
Fully test the control system prior to silicone
DATA CABLE

IMPORTANT! READ INSTALLATION AND PRODUCT GUIDE P/N 81127
STEP 2
OPTIONAL MODES
SILICONE (INCLUDED)
ThermaSol Steam Bath Co. 1958 Steam Way, Round Rock, TX 78665
Toll-free: 800.776.0711 Fax: [phone]
Visit us online @ www.thermasol.com
81132R Rev B P-2 10/14 JWJ
Once desired fit is achieved coat back
of control face with supplied silicone.
Firmly press to wall surface and wipe
excess silicone from around control.
Tape into LEVEL position and allow
24 hours to completely dry.
i
Once finished tile is completed remove mud ring from
wall. Ensure that a total minimum depth is 5/8” so control
face sits flush to wall. Connect cable so it is not lost in
wall. Test fit for flushness.
STEP 3
BEFORE TILE -Using the supplied mud ring
attach to wall face using a few standard
screws. Tile to edge of mud ring.
MUD RING INSTALLATION
***FOR RECESSED MODERN CONTROLS ONLY***
TPMR-XX (XX- DENOTES FINISH)
STEP 1
IMPORTANT NOTE:
Fully test the control system prior to silicone
DATA CABLE