THERMEx Easy Compact Heatpump User manual

Easy Compact Heatpump
BEFORE INSTALLING AND USING THIS AIR CONDITIONER PLEASE READ ALL
INSTRUCTIONS CAREFULLY

1
2
4
5
5
6
7
8
9
10
P0
3
11
13
12
WZ-28EC

W
P1
2565(9000)
2555(9000)
924
831
400
4.2
2088
48
3.8
50
22.5
Easy Compact Heatpump

2m
P3
2m
Outdoor Indoor
P4
spirit level

P5
3° INCLINATION
P13
Soft terminal
Hard terminal
A
A
B
B
System "A" is more common use , and the
discharge pipe go outside where there is
no problem to connect or to discharge it ,
this solution is OK for hot country and
normal cold temperature out side .

P6
P20
The pipe with a diameter of 160mm (air
(Fresh air intake)
Usually "B" hole is used in the installation
when the outside temperature is very low,
and in this way we prevent no ice in the
discharge water pipe . This solution is used
also to be more easy for the installer to
connect the internal drainage pipe when he
don't want to see the pipe from outside.

P7
P8
P10
P9

LIFT IT UP
HERE
P11
P12
LIFT IT UP
HERE Water
P14
Water cap

Press the ON/OFF button " ", switch on the
air conditioner, it will run by memory mode.
Press the MODE button " " set up the
mode to fan " ", the air conditioner will
run in fan.
Press UP " " or DOWN " " button, to
adjust the setting up temperature.
Press the FAN SPEED button " ", set up
the fan speed. is low speed, is middle
speed, is high speed, (flashing) is auto
speed.
Fan auto fan, the speed is choosen by the
difference of room temperature and setting
temperature.
Room temperature-setting temperature＞5℃,
high speed.
Room temperature-setting temperature＞3℃,
middle speed.
Room temperature-setting temperature＞1℃,
low speed.
Press the ON/OFF button " ", switch off
the air conditioner. Next time when this
button is pressed, the air conditioner will
operates in this mode by memory.

Close position

LIFT IT UP
HERE
LIFT IT UP
HERE
P15
P16
P17
P19
P18