Thermo EMEVN-204 User manual

Page 1 av 3 EMEVN-204
Thermo AS, Eternitveien 45, N-3470 Slemmestad
Telefon [phone], E-post: [e-mail]
www.thermo-varme.no
ASSEMBLY INSTRUCTIONS FOR EVN -NAVARE AIR HEATERS EMEVN-204
Archive : instruks/emevn 204.doc Date 02.11.2018
Replaces : instruks/emevn203.doc Responsible: RJH
INSPECTION ON DELIVERY
Check to ensure that no visible damage has occurred during transport, that you have received the
correct model and that voltage and output are correct.
APPROVAL/AREA OF USE
The heaters are approved by Det Norske Veritas, certificate TAE00002XD for use on board ships and
offshore units, tightness IP44.
SAFETY INSTRUCTION
- the appliance is not to be used by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction
- children being supervised not to play with the appliance
- this appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved
- children shall not play with the appliance
- cleaning and user maintenance shall not be made by children without supervision
- children of less than 3 years should be kept away unless continuously supervised.
-children aged from 3 years and less than 8 years shall only switch on/off the appliance
provided that it has been placed or installed in its intended normal operating position and they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years and less than 8 years shall not
plug in, regulate and clean the appliance or perform user maintenance.
CAUTION —Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are present.

Page 2 av 3 EMEVN-204
Thermo AS, Eternitveien 45, N-3470 Slemmestad
Telefon [phone], E-post: [e-mail]
www.thermo-varme.no
PLACEMENT AND LOCATION
The EVN heater must be attached to the enclosed wall bracket with at least 4 pcs. M6 bolts for the
bracket. All 6 screws to the cabinet must be used.
Heater is not located immediately below a socket-outlet
Safety distance shown on sketch must be followed.
Sketch with safety distances.
ELECTRICAL INSTALLATION
Electrical installations must be carried out by an authorized electrical contractor.
Support cable and any extra cable for external thermostat and remote control switch may be of
standard marine type. Make sure that the screws in terminal are properly tightened on both sides.
Check for correct function of the fan and the two groups. Operate the regulation switch and the
thermostat.
The cover must be properly secured.
INSTRUCTIONS FOR USE
The heater has a built-in thermostat. The temperatures can be set between 0 –400C.
1. 0 The fan is switched off.
2. The fan starts running. The heat is not switched on.
3. •The fan is running and the thermostat switches the heating elements
on to 1/2 load.
4. █The fan is fully loaded.

Page 3 av 3 EMEVN-204
Thermo AS, Eternitveien 45, N-3470 Slemmestad
Telefon [phone], E-post: [e-mail]
www.thermo-varme.no
MAINTENANCE
oMake maintenance routines.
oCheck the inlet and outlet grids for dirt, and clean with pressure air.
oThick layers of dust on the surface of the heater constitute a fire hazard.
oDo not store objects on or immediately until the appliance.
oPay particular attention to fan blow noise, contactors like buzzer, loose controls, etc. The
power of the appliance should be checked by measuring the current at the highest heat level.
oLeave the fan at full speed/effect for at least 2 hours every second month so that any moisture
entering the fan evaporates and does not contribute to rust in bearings.
oUse a dry brush / cloth to clean the fan.
oDo not use corrosive cleaners.
oAvoid water entering the engine or electrical system.
REPAIRS
Repairs must only be carried out by an authorized electrical contractor.
When ordering spare parts, it is important to specify the correct type of heater, output and voltage,
as well as the production date and description of the spare part.
Spare parts
You will find this described in the wiring diagram inside the cover.
Article
number
Type
Effect
Voltage
Phase
kW
m3/h
kg
Amp
t
m/s
Level
dB(A)
4927710
EVN 3-23
3kW
230/3
1,5-3
1300
15
7,5
6,7
3,0
55
4927711
EVN 6-23
6kW
230/3
3-6
1300
18
15,3
13,4
3,0
55
4927713
EVN 3-40
3kW
400/3
1,5 - 3
1300
15
5,0
6,7
3,0
55
4927714
EVN 6-40
6kW
400/3
3-6
1300
18
9,0
13,4
3,0
55
4927715
EVN 9-40
9kW
400/3
4,5 - 9
1300
19
13,0
20,0
3,0
55
4927716
EVN 3-44
3kW
440/3 60Hz
1,5 - 3
1500
17
4,0
5,8
3,5
55
4927717
EVN 6-44
6kW
440/3 60Hz
3-6
1500
20
8,0
11,6
3,5
55
4927718
EVN 9-44
9kW
440/3 60Hz
4,5 - 9
1500
21
12,0
17,4
3,5
55