Thinget XC3 Series User manual

THINGET
XC3 Series Programmable Controller
Installation Guide Functions
-Dry and no dew - Insulate voltage: Up to DC 500V
-Fr from corrosive gases and dusts - Anti noise: 1000 V 1uS pulse per minute
-Don’t install he unit in areas subject to -Ambient temperature: 0~60 C
Liquid chemicals -Ambient humidity: 5~95% (no dew)
Wiring -COM1: RS232, connect with host machine, HMI program or debug
-Far from the high voltage, power supply or -COM2: RS232/RS485, connect with network or aptitude instrument
Cable with high current -COM3: BD board COM port RS232/RS485
-Never over voltage, make sure the polarity of -Installation:can use M3 screw to fix or install directly on DIN46277
Power supply is correct -Grounding: The third type grounding (cant public ground with strong
power system)
Power Specification -to avoid voltage decrease please use cable thicker than
2mm
- Even appear power cut within 10ms; PLC can still go
on working. But if long time power cut or abnormal
power decrease, PLC will stop working, output will
also appear OFF status, when recover power supply, the
PLC will auto to work.
- Connect the grounding terminals of basic units and
extend modules together, then ground.
Output Specification Input Specification
Terminal arrangement
1-Input Terminals 2- BD expansion
3-Input Label 4-COM port
5-COM port 6-COM port's cover board
7-Output label 8-Output terminals
9-Screws 10-Input indicate LED
11-Extension port
12-Programming status indicate LED
13-Output indicate LED
Rated Voltage AC 100V~240V
Voltage allow bound AC 90V~265V
Rated frequency 50/60 Hz
Allow momentary
power-cut time Interrupt time<0.5AC cycle,alternation>1sec
Impact current Max 40A 5ms below/AC100V
Max 60A 5ms below/AC200V
Max power consumption 12W
Power for sensor use 24V DC max400mA
Transistor
Output
Relay outputItems
Below DC5~30VBelow
AC250V,DC30V
Interior power
Optical coupling
insulation
Mechanism
insulation
Circuit insulation
Indicate lamp LEDAction denote
0.8A3AResistance
load 12W/DC24v80VAInductive
load 1.5W/DC24V100WLamp load
Max
Load
DC5V 2mAMini load Below 0.2ms10msOFF to
ON Below 0.2ms10msON to
OFF
Response
time
DC24V
Input signal's voltage 7mA/DC24V
Input signal's current Up to 4.5mA
Input on current Law than 1.5mA
Input off current About 10ms
Input response time Contact input or
NPN
open collector
transistor
Input signal's format
Photo-electricity
coupling insulation
Circuit insulation
LED light when
input ON
Input action's display

Com Port Definition
Com Port 1: Com Port2: Connection of programmable cable is the following：
4: RXD
5: TXD8: GND
Input / Output Example
Overall Dimension
XC3 series 14 points main unit (including 16 points expansion) XC3 other types
L2 (mm)L1 (mm)XC3 Other types 139131XC3 24/32 points main unit,32 points expansion 207.4199.4XC3 48/60 points main unit
2: PRG4: RxD5: TxD6: VCC8: GND