thomann Combo Stand 40 User manual

Combo Stand 40''
Assembly Manual
Thomann GmbH
Hans-Thomann-Straße 1
96138 Burgebrach
Germany
Telephone: [phone]
Internet: www.thomann.de
18.09.2023, ID: 568216
General information
This document contains important information for the safe
use of the product. Read and follow the safety notes and all
other instructions. Keep the document for future reference. If
you pass on the product, please also include this document.
The right to make changes is reserved. Please refer to the
latest version of the documentation, which is ready for
download under www.thomann.de.
Intended use
This product is used to set up speaker boxes. Any other use or
use under other operating conditions is considered to be
improper and may result in personal injury or property
damage. No liability will be assumed for damages resulting
from improper use. This product may be used only by persons
with sufficient physical, sensorial, and intellectual abilities and
having corresponding knowledge and experience. Other
persons may use this product only if they are supervised or
instructed by a person who is responsible for their safety.
Risk of injury and choking hazard for children!
Children can suffocate on packaging material and small parts.
Children can injure themselves when handling the product.
Never allow children to play with the packaging material and
the product. Always store packaging material out of the reach
of babies and small children. Always dispose of packaging
material properly when it is not in use. Never allow children to
use the product without supervision. Keep small parts away
from children and make sure that the product does not shed
any small parts that children could play with.
Risk of cuts to the hands from sharp edges during assembly!
Tools, screws and components can have sharp edges that can
cause cuts during assembly. Pay attention to sharp edges
when assembling and screwing the individual parts. Wear
protective gloves if necessary.
Risk of injury due to tipping of the stand during loaded
transport!
If the stand is moved without removing the loaded
equipment, the stand may tip over and cause injuries and
property damage. Always remove equipment from the stand
before moving the stand.
Risk of injury due to tipping of stand on an unsuitable
ground!
If the stand is placed on soft or uneven ground, it may
overturn and cause injuries and property damage. Place the
stand only on flat and solid ground.
Risk of injury due to tipping of the stand from excessive
loading!
In case of excessive loading, the stand might tip over,
causing injury and property damage. Never exceed the
specified maximum load for the stand.
For the packaging, environmentally friendly materials have been
chosen that can be supplied to normal recycling. Ensure that
plastic bags, packaging, etc. are properly disposed of. Do not just
dispose of these materials with your normal household waste, but
make sure that they are collected for recycling. Please follow the
notes and markings on the packaging.

A
C
B
D
C
B
Push wooden dowels type W in the appropriate holes
STEP 1

STEP 2 STEP 3
Use screws Type E Use screws Type E
D
C
A
C
B

Type W
Wooden dowels Euro Screws Hex wrench
PACKING LIST:
x12 Type E
x14 Type H
x1
Felt Support
Type Fs
x16
TOOLS:
35 mm
INSTRUCTION FOR USE AND CLEANING
- clean with a soft cloth, slightly humid or specific products for wood or lacquer;
- avoid the use of abrasive cleaners.
STEP 4
Use Felt Support Type Fs