thomann Millenium BS-2010 User manual

BS-2010
Stand
User Manual

Thomann GmbH
Hans-Thomann-Straße 1
96138 Burgebrach
Germany
Telephone: [phone]
Internet: www.thomann.de
30.10.2023, ID: 320824 (V3)

Table of contents
1 General information................................................................................................................................. 5
1.1 Symbols and signal words............................................................................................................... 5
2 Safety instructions..................................................................................................................................... 7
3 Features.......................................................................................................................................................... 9
4 Operation.................................................................................................................................................... 10
5 Technical specications....................................................................................................................... 14
6 Protecting the environment.............................................................................................................. 16
Table of contents
BS-2010 3
Stand

4BS-2010
Stand

1 General information
This document contains important instructions for the safe operation of the product. Read and
follow the safety instructions and all other instructions. Keep the document for future refer‐
ence. Make sure that it is available to all those using the product. If you sell the product to
another user, be sure that they also receive this document.
Our products and documentation are subject to a process of continuous development. They
are therefore subject to change. Please refer to the latest version of the documentation, which
is ready for download under www.thomann.de.
1.1 Symbols and signal words
In this section you will nd an overview of the meaning of symbols and signal words that are
used in this document.
General information
BS-2010 5
Stand

Signal word Meaning
DANGER! This combination of symbol and signal word indicates an
immediate dangerous situation that will result in death or
serious injury if it is not avoided.
CAUTION! This combination of symbol and signal word indicates a pos‐
sible dangerous situation that can result in minor injury if it
is not avoided.
NOTICE! This combination of symbol and signal word indicates a pos‐
sible dangerous situation that can result in material and
environmental damage if it is not avoided.
Warning signs Type of danger
Warning – danger zone.
General information
6BS-2010
Stand

2 Safety instructions
This speaker stand is used for stable xing and height-adjustable installation of loudspeaker
cabinets. Use the product only as described in this user manual. Any other use or use under
other operating conditions is considered to be improper and may result in personal injury or
property damage. No liability will be assumed for damages resulting from improper use.
This product may be used only by persons with sucient physical, sensorial, and intellectual
abilities and having corresponding knowledge and experience. Other persons may use this
product only if they are supervised or instructed by a person who is responsible for their safety.
Safety
DANGER!
Risk of injury and choking hazard for children!
Children can suocate on packaging material and small parts. Children can injure themselves when handling the product. Never
allow children to play with the packaging material and the product. Always store packaging material out of the reach of babies and
small children. Always dispose of packaging material properly when it is not in use. Never allow children to use the product without
supervision. Keep small parts away from children and make sure that the product does not shed any small parts that children could
play with.
CAUTION!
Risk of injury due to tipping of the stand during loaded transport!
If the stand is moved without having removed the installed devices, the stand may tip over and cause injuries and property damage.
Remove the installed devices before transporting the stand.
Intended use
Safety instructions
BS-2010 7
Stand

CAUTION!
Risk of injury due to tipping of stand on an unsuitable ground!
When the stand is installed on soft or uneven ground, the stand may tip over and cause injuries and property damage. Install the
stand only on even and solid ground.
CAUTION!
Risk of injury due to tipping of the stand from excessive loading!
In case of excessive loading, the stand might tip over, causing injury and property damage. Never exceed the specied maximum
load for the stand.
NOTICE!
Possible staining due to plasticiser in rubber feet!
The plasticiser contained in the rubber feet of this product may react with the coating of the oor and cause permanent dark stains
after some time. If necessary, use a suitable mat or felt slide to prevent direct contact between the device’s rubber feet and the oor.
Safety instructions
8BS-2010
Stand

3 Features
Special characteristics:
nSteel speaker stand
nExtendible up to a height of about 2 m
nCentric load capacity up to 30 kg
n25 mm pipe diameter at the pole mount
nIncluding adapter from 25 mm diameter to M6 thread (12 mm long)
nFoot diameter 1000 mm
nTransport length when folded: 1.19 m
Features
BS-2010 9
Stand

4 Operation
Unpack and check carefully there is no transportation damage before using the product. Keep
the equipment packaging. To fully protect the product against vibration, dust and moisture
during transportation or storage use the original packaging or your own packaging material
suitable for transport or storage, respectively.
CAUTION!
Risk of injury due to tipping of the stand from excessive loading!
In case of excessive loading, the stand might tip over, causing injury and property
damage.
Never exceed the specied maximum load for the stand.
CAUTION!
Risk of injury due to tipping of stand on an unsuitable ground!
When the stand is installed on soft or uneven ground, the stand may tip over and
cause injuries and property damage.
Install the stand only on even and solid ground.
Operation
10 BS-2010
Stand

CAUTION!
Risk of injury due to tipping of the stand during loaded transport!
If the stand is moved without having removed the installed devices, the stand
may tip over and cause injuries and property damage.
Remove the installed devices before transporting the stand.
Comply with regulations
When installing and operating, make sure to follow the standards and regulations
that apply in your country.
Operation
BS-2010 11
Stand

Perform the steps described below:
1. Unfold the feet of the stand until the cross braces are in a horizontal position.
2. Fix this position with the safety screw on the carriage to which the three feet are
attached.
3. Pull out the safety cotter and loosen the safety screw on the extension tube.
4. Pull out the extension tube to the desired height and slide the safety cotter through the
corresponding grid hole.
5. Fix the position of the extension tube with the safety screw on the extension tube.
6. Flange the speaker box to the top of the extension tube. Use the adapter supplied with
the stand if necessary. The weight of the speaker box to be set up must not exceed the
maximum centric load of 30 kg.
Setup
Operation
12 BS-2010
Stand

1. Remove the speaker box.
2. Pull out the safety cotter and hold the extension tube while you loosen the safety screw
on the extension tube.
3. Slide the extension tube all the way down and slide the safety cotter through the corre‐
sponding grid hole.
4. Fix the position of the extension tube with the safety screw on the extension tube.
5. Loosen the safety screw on the carriage to which the three feet are attached.
6. Fold up the feet of the stand.
Disassembly
Operation
BS-2010 13
Stand

5 Technical specications
Height, max. 2.00 m
Adjustable stand height 1.19 m … 2.00 m
Footprint Æ1.00 m
Stand tube diameter Æ25 mm
Mount type Flange, Æ25 mm
Adapter, Æ25 mm / M6 thread
Load, max. (with centric load) 30 kg
Transport length when folded 1.19 m
Weight 2.6 kg
Colour Black
Technical specications
14 BS-2010
Stand

Set of 2 stands No
Material Steel
Crank stand No
Ringlock No
Pneumatics No
Foot type Tripod
Further information
Technical specications
BS-2010 15
Stand

6 Protecting the environment
Environmentally friendly materials have been chosen for the packaging. These materials can
be sent for normal recycling. Ensure that plastic bags, packaging, etc. are disposed of in the
proper manner.
Do not dispose of these materials with your normal household waste, but make sure that they
are collected for recycling. Please follow the instructions and markings on the packaging.
Observe the disposal note regarding documentation in France.
Disposal of the packing material
Protecting the environment
16 BS-2010
Stand

Notes
BS-2010 17
Stand

Notes
18 BS-2010
Stand

Musikhaus Thomann · Hans-Thomann-Straße 1 · 96138 Burgebrach · Germany · www.thomann.de