TigerTough E82219 User manual

It’s not rocket science,
but following these
instrucons will make
installing your seat covers
a lot easier.
We promise.
E82219
KOMATSU EXCAVATOR SEAT
COVER
PART:
PRODUCT:
PIECES: (1) SEAT BACK COVER
(1) SEAT BOTTOM COVER
(1) HEADREST COVER
FOR INSTALL HELP, CALL 507.246.3545

General care instructions:
1. In most cases dirt, debris, spills and pet hair can be removed by wiping with a
damp cloth.
2. Seat covers can be removed and machine washed on low temperature setting
using mild detergent.
Drip dry or machine tumble dry on a no heat cycle.
Straps should be coiled and secured with rubber bands for machine washing
and drying.
3. Soil may be removed with spray cleaner or detergent and water.
4. Oil or grease stains should rst be treated with a dry cleaning solvent followed
by a spray cleaner or detergent and water.
5. Do not use bleach.
Your new seat covers are covered by a
two-year, unconditional, no B.S. warranty.
That means that if you manage to abuse
them to a point that they can’t perform like
they’re supposed to within two years of when
you bought them, we’ll make it right.
Depending on what is more practical, we’ll
either repair or replace the damaged cover.
Basically, you break it, we buy it.
Seriously.

Install Cover
Undo the velcro tabs
on the seat cover.
Begin pulling the
cover on with the
pocket facing the
back.
Work the cover down
the seat back. Pull
around the gray knob
on the side and tuck
the seam in around it.
Fasten tabs under the
headrest to the velcro
on the edge og the
cover as show.
Push the tabs in
between the seat back
and seat bottom.
Fasten the tab beneath
the headrest to the
velcro on the inside of
the cover.
Place the seat bottom
cover over the seat
bottom.
Tuck fabric around
the plastic trim of the
adjustment handle at
the front.
Push ap in between
the seat back and seat
bottom.
Pull tight and secure
velcro.
22
11
33
44
55
77
66
88
[View from back of
seat]
Pull tight and secure to
the velcro at the back.
3377

Install Cover
Undo the velcro tabs
on the seat cover.
Begin pulling the
cover on with the
pocket facing the
back.
Work the cover down
the seat back. Pull
around the gray knob
on the side and tuck
the seam in around it.
1010
9955
[View from back of
seat]
Pull tight and secure to
the velcro at the back.
1111
MISSION ACCOMPLISHED