tilebar Mona Series User manual

p. 1
STEP 1
STEP 2
Wall blocking is required for all installation.
The suggested heights without the sink are 30-5/8” for our Resin Basin, or
32-5/8” for our Ceramic Basin. Depending on the sinks selected, the total
height will vary from 33-1/2”(850mm) to 35-1/4”(895mm). If an alternate
height desired, adjust the rough-in and backing material heights using the
dimensions provided. • Mark pre-drilled holes with a pencil or marker after positioning the vanity.
• Drill the holes with suitable drill-bits base on different condition of the
• White rubber plug for brick or concrete wall.
Wood Reinforcement
Board Minimum Size 8”
Width of the
Vanity or Longer
Suggestion Install Height:
33-1/2”(850mm) to
35-1/4”(895mm)
INSTALLATION GUIDE Mona Collection

p. 2
STEP 4STEP 3
• Fix the cabinet to the wall with screw C and cover it with a stainless
steel lid D.
• Screw the lifting foot into the screw hole at the bottom.
• The adjusting screw at the bottom of the metal foot can be raised
0-9/16”(0-15mm).
INSTALLATION GUIDE Mona Collection

p. 3
STEP 6STEP 5
• Installation complete.• Install the basin with silicone.
INSTALLATION GUIDE Mona Collection