Tilia Table Moon User manual

ASSEMBLY SCHEMA
Table Moon/Moon-S
Contents
a)
c)
e)
b) d)
f) g)
1 pc. Tabletop with Cross
1 pc Metal Tube
1 pc Washer
1 pc Moon Leg 1 pc Weight Mounted Driftbolt
1 pc Fibered Nut 2 pcs M10 Nuts
MOON TABLETOP 60Ø MOON-S TABLETOP 70Ø MOON TABLETOP 70x70cm
1
4
3
2
Remove the
pin from the
mechanism.
Place a nut
(g) inside the
slot behind the
handle
Remove fibered
nut (f) and washer
(e) and one of the
nuts (g) from the
driftbolt (d)
Lift the handle to release the
mechanism, then lift the moving
part of the mechanism together
with handle until it’s open
completely.
a
g
Please be sure not the miss any screw holes and fasten all screws equally and tightly. Otherwise, you may face breakage or cracking
during the time of usage.
(Foldable)
f e g g
V09032021

9Tighten the nut
with a 17 wrench
or ratchet.
5
67
Ensure there is one nut (g)
available on the long side of the
balance weight. Place the long
side of the balance weight into
the mechanism, then tighten the
nut (g) with 17 wrench.
Close the mechanism
together with the
balanced weight
(no interaction with
handle required)
Install the
pin to the
mechanism
dg
8Place the
aluminum tube
(c) until it covers
the driftbolt with
balance weight
(d). Then place the
table leg (b) under
the aluminum
tube, make sure to
fit the notch. Then
insert the washer
(e) and fibered
nut (f).
b
e
f
cThe direction of closure
of the table and
the notch of the leg
must be in the same
direction