Time2 Clan Noah User manual

Outdoor Siren User Guide
Connect the outdoor siren to the Noah hub as an additional siren.
The siren acts as a repeater so when Noah is armed, it will make a
loud beeping sound to alert you and the built-in strobe LED will flash
continuously acting as a deterrent.
If the alarm is triggered, the siren will sound for 5 minutes and the
strobe LED will flash quickly.
Pairing the outdoor siren to the Noah Hub
Please ensure the outdoor siren has been paired with the Noah Hub
prior to mounting the siren outdoors
You will need the following to pair the siren to the Noah hub.
-Outdoor siren
-Noah hub
-Remote Control (provided with the Noah hub)
-Clan at Home app on your smartphone
1. Plug the siren in to power using the UK power adapter provided
2. Open the back cover of the siren and press the blue power button
to switch the siren on.
The siren will make a beeping sound when it is on.
3. Open the Clan at Home app on your smartphone

4. Click on Noah Alarm System
5. Press the icon on the Noah dashboard to enter the
accessories menu
6. Press the (+Add) icon. The Noah hub LED will turn purple when it is
ready for pairing.
7. Then press the pairing button on the back of the siren. The siren
will enter pairing mode –the strobe LED will come on and the siren
will make a beeping sound
8. Use the remote control to arm Noah
9. Then press the pairing button on the back of the siren again
10. Lastly, test the outdoor siren by using the remote control to arm
Noah again. The outdoor siren will also make a beeping noise.
Please note: As the siren acts as a repeater to the Noah Hub, it does
not appear in the Accessories menu.
Where to install the outdoor siren
Fit the siren to the outside of your home where it is clearly visible and
at a height that is not easily accessible by an intruder.
Mount the siren at a distance of more than 1 metre away from any
external or internal metalwork such as drainpipes, gutters, radiators
etc.

Installing the outdoor siren
Before the outdoor siren is mounted, ensure the siren is in
Installation Mode, this reduces the risk of the siren being triggered
whilst being installed.
To activate installation mode, simply press the disarm button on the
remote control 3 times. The strobe LED will flash continuously when
the siren is in installation mode.
To install the outdoor siren, see steps below:
1. Use a piece of paper to create a screw
template for the siren and mark the correct
screw positions onto the wall
2. Using the screw template, drill the screws into
the wall
3. Connect the siren to a main power supply
using the charging adapter provided
4. Finish mounting by fixing the siren on to the
screws and position into place.
Once the siren has been installed successfully.
Press the disarm button on the remote control
again to deactivate installation mode.