STI Theft Stopper STI-6200 Series Instruction sheet

The Stopper®
1. Remove security screw
with provided wrench.
2. To remove cover from base,
push with thumb to separate
(as shown).
3. Select volume setting by
shifting black cap.
4. Unwrap battery and connect. Insert 6” service
cables into base to silence. Cable should not
exceed past base edge.
7. Apply language label if desired.
2
1
2
#8-10 x 7/8 in.
PLASTIC ANCHOR
(4) PROVIDED
POLYCARBONATE BASE
PRINTED CIRCUIT BOARD
VOLUME CONTROL JUMPER
SEE AUXILIARY VIEW
KIT-H19016 TAMPER WRENCH
#8-32 x 3/8 in.
TRUSS HEAD TAMPER SCREW
KIT-18015-9 DEACTIVATION/SERVICE CABLE
#8 x 1 in. SCREW
(4) PROVIDED
9 VOLT BATTERY
POLYCARBONATE COVER
CIRCUIT BOARD
CAP ON 2 RIGHT PRONGS
FOR HIGH VOLUME (DEFAULT)
CAP ON 2 LEFT PRONGS
FOR LOW VOLUME
5.375 in.
(137mm)
2 in.(51mm) DEPTH
VIEW SHOWING BATTERY REPLACEMENT
9 VOLT BATTERY
VIEW SHOWING JUMPER LOCATION
FOR VOLUME SETTTINGS
OPTIONAL LABEL
VIEW SHOWING BATTERY
REPLACEMENT
9 VOLT BATTERY
OPTIONAL LANGUAGE LABEL
HORN/SOUNDER
95/105dB
5.375 in.
(137mm)
2 in.(51mm) DEPTH
16”-18” CABLE
CABLE
VOLUME
5. Position base. Mark and drill four (4) holes 1”
(25mm) deep. Using plastic anchor, drill 3/16”
(4.5mm). Install into wood or steel: drill 9/64”
(3.5mm). Mount using (4) M4 x 25mm screws.
NOTE: Cable is approximately 16” – 18” long.
6. Replace cover, snap lid from top,
secure with security screw.
MOUNTING
HOLES
MOUNTING
HOLES
KIT-18015-9
DEACTIVATION/SERVICE CABLE
MOUNTING
HOLES
MOUNTING
HOLES
KIT-18015-9
DEACTIVATION/SERVICE CABLE
Install
STI-6200 Series
Rely on STI®

8. Route operating cable around a secure location on appliance and through cable sleeve clamp, and
crimp securely. Assure it does not impede proper use of appliance.
Examples:
9. Quickly remove service cable and
thread operating cable into unit
until cable bottoms out and alarm
stops sounding. Retain service
cable for future maintenance.
#8-10 x 7/8 in.
PLASTIC ANCHOR
(4) PROVIDED
POLYCARBONATE BASE
PRINTED CIRCUIT BOARD
VOLUME CONTROL JUMPER
SEE AUXILIARY VIEW
H19016 TAMPER WRENCH
#8-32 x 3/8 in.
TRUSS HEAD TAMPER SCREW
KIT-18015-9 DEACTIVATION
/SERVICE CABLE
#8 x 1 in. SCREW
(4) PROVIDED
9 VOLT BATTERY
POLYCARBONATE COVER
THREAD CABLE INTO THEFT STOPPER
UNTIL CABLE BOTTOMS OUT
(TO TEST, SIMPLY PULL CABLE
AND HORN WILL SOUND)
ROUTE CABLE AROUND EXTINGUISHER
NECK AND THROUGH CABLE SLEEVE CLAMP.
CRIMP SECURELY AS SHOWN MAKING SURE
CABLE LOOP WILL NOT SLIP OVER NECK
CIRCUIT BOARD
CONNECTOR POSITION
FOR HIGH VOLUME
CONNECTOR POSITION
FOR LOW VOLUME
5.375 in.
(137mm)
2 in.(51mm) DEPTH
VIEW SHOWING BATTERY REPLACEMENT
9 VOLT BATTERY
VIEW SHOWING JUMPER LOCATION
FOR VOLUME SETTTINGS
OPTIONAL LABEL
VIEW SHOWING
BATTERY REPLACEMENT
9 VOLT BATTERY
OPTIONAL LANGUAGE LABEL
HORN/SOUNDER
95/105dB
5.375 in.
(137mm)
2 in.(51mm) DEPTH
OPERATING CABLE
AND SLEEVE CLAMP
#8-10 x 7/8 in.
PLASTIC ANCHOR
(4) PROVIDED
POLYCARBONATE BASE
PRINTED CIRCUIT BOARD
VOLUME CONTROL JUMPER
SEE AUXILIARY VIEW
H19016 TAMPER WRENCH
#8-32 x 3/8 in.
TRUSS HEAD TAMPER SCREW
KIT-18015-9 DEACTIVATION
/SERVICE CABLE
#8 x 1 in. SCREW
(4) PROVIDED
9 VOLT BATTERY
POLYCARBONATE COVER
THREAD CABLE INTO THEFT STOPPER
UNTIL CABLE BOTTOMS OUT
(TO TEST, SIMPLY PULL CABLE
AND HORN WILL SOUND)
ROUTE CABLE AROUND EXTINGUISHER
NECK AND THROUGH CABLE SLEEVE CLAMP.
CRIMP SECURELY AS SHOWN MAKING SURE
CABLE LOOP WILL NOT SLIP OVER NECK
CIRCUIT BOARD
CONNECTOR POSITION
FOR HIGH VOLUME
CONNECTOR POSITION
FOR LOW VOLUME
5.375 in.
(137mm)
2 in.(51mm) DEPTH
VIEW SHOWING BATTERY REPLACEMENT
9 VOLT BATTERY
VIEW SHOWING JUMPER LOCATION
FOR VOLUME SETTTINGS
OPTIONAL LABEL
VIEW SHOWING
BATTERY REPLACEMENT
9 VOLT BATTERY
OPTIONAL LANGUAGE LABEL
HORN/SOUNDER
95/105dB
5.375 in.
(137mm)
2 in.(51mm) DEPTH
OPERATING CABLE
AND SLEEVE CLAMP
The Stopper®
Install
STOP
EMERGENCY USE ONLY
STOP
EMERGENCY USE ONLY
SOUNDS WHEN EXTINGUISHER IS
ALARM
REMOVED
#8-10 x 7/8 in.
PLASTIC ANCHOR
(4) PROVIDED
POLYCARBONATE BASE
PRINTED CIRCUIT BOARD
VOLUME CONTROL JUMPER
SEE AUXILIARY VIEW
KIT-H19016 TAMPER WRENCH
#8-32 x 3/8 in.
TRUSS HEAD TAMPER SCREW
KIT-18015-9 DEACTIVATION/SERVICE CABLE
#8 x 1 in. SCREW
(4) PROVIDED
9 VOLT BATTERY
POLYCARBONATE COVER
POLYCARBONATE COVER
SERVICE CABLE
POLYCARBONATE BASE
105 dB/95 dB HORN
CIRCUIT BOARD
CONNECTOR POSITION
FOR HIGH VOLUME
CONNECTOR POSITION
FOR LOW VOLUME
STOP
EMERGENCY USE ONLY
ALARM SOUNDS WHEN CHAIR IS REMOVED
5.375 in.
(137mm)
2 in.(51mm) DEPTH
VIEW SHOWING JUMPER LOCATION
FOR VOLUME SETTINGS
ALARM SOUNDS WHEN CHAIR IS REMOVED
THREAD CABLE INTO
THEFT STOPPER UNTIL
CABLE BOTTOMS OUT
(TO TEST, SIMPLY PULL
CABLE AND HORN
WILL SOUND)
ROUTE CABLE AROUND
EVACUATION CHAIR AND
THROUGH CABLE SLEEVE CLAMP.
CRIMP SECURELY AS SHOWN
MAKING SURE CABLE LOOP
WILL NOT SLIP OFF CHAIR.
STOP
EMERGENCY USE ONLY
ALARM SOUNDS WHEN CHAIR IS REMOVED
Fire Extinguisher Emergency Chair
6200 INSTALL
JAN2019
Subject to change
without notice.
#8-10 x 7/8 in.
PLASTIC ANCHOR
(4) PROVIDED
POLYCARBONATE BASE
PRINTED CIRCUIT BOARD
VOLUME CONTROL JUMPER
SEE AUXILIARY VIEW
KIT-H19016 TAMPER WRENCH
#8-32 x 3/8 in.
TRUSS HEAD TAMPER SCREW
KIT-18015-9 DEACTIVATION/SERVICE CABLE
#8 x 1 in. SCREW
(4) PROVIDED
9 VOLT BATTERY
POLYCARBONATE COVER
CIRCUIT BOARD
CAP ON 2 RIGHT PRONGS
FOR HIGH VOLUME (DEFAULT)
CAP ON 2 LEFT PRONGS
FOR LOW VOLUME
5.375 in.
(137mm)
2 in.(51mm) DEPTH
VIEW SHOWING BATTERY REPLACEMENT
9 VOLT BATTERY
VIEW SHOWING JUMPER LOCATION
FOR VOLUME SETTTINGS
OPTIONAL LABEL
VIEW SHOWING BATTERY
REPLACEMENT
9 VOLT BATTERY
OPTIONAL LANGUAGE LABEL
HORN/SOUNDER
95/105dB
5.375 in.
(137mm)
2 in.(51mm) DEPTH
16”-18” CABLE
CABLE
VOLUME
OPERATING CABLE
AND SLEEVE CLAMP
Defibrillator
WARNING: This product can expose you to chemicals including Dichloromethane, which is known to the
State of California to cause cancer, and Bisphenol A (BPA), which is known to the State of California to
cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Warranty
Three year warranty or a one year limited warranty (from date of purchase) on most products.
See website for details. Electronic warranty form at www.sti-usa.com/wc14.
2306 Airport Rd • Waterford, MI 48327, USA
Phone: [phone] • Fax: [phone]
[email protected] • www.sti-usa.com
Taylor House • 34 Sherwood Road • Bromsgrove, Worcestershire • B60 3DR • England
Tel: [phone] • Fax: [phone] • [email protected] • www.sti-emea.com