tive TT-6000 User manual

Confidential and Proprietary. All Rights Reserved. © 2021 Tive, Inc. Page 1 of 2
Tive Temperature Beacon (TT-6000)
The TT-6000 is a wireless temperature monitor designed for all applications requiring package-
level temperature monitoring. The TT-6000 works together with the Tive Tracking solution to offer
full real-time visibility of temperature and location. The device is easy to use and can be mounted
to most surfaces for a wide range of applications. The device is fully IATA approved for use on all
airlines.
Figure 1 - Tive Sensor Tag (TT-6000)
Power On: Press the CHECK button for 3-5 seconds and the blue light should turn on.
Power Status: Press the CHECK button. The Status light(s) ill blink if the Beacon is On.
hen the device is ON, the TT-6000 will broadcast the temperature reading every 3.3 sec using
the Bluetooth advertisement channels (Ch 37, Ch 38, Ch 39) using a standard Non-Connectable
Advertisement packet (ADV_NONCONN_IND). The device will continue broadcasting until the
battery is too low.
Power utton
Status Light

Confidential and Proprietary. All Rights Reserved. © 2021 Tive, Inc. Page 2 of 2
Specifications
Dimensions 66.5 mm x 56 mm x 6.7 mm
Weight 25 g (0.9 oz)
Case Material UL 94-V0 flame retardant plastic
Waterproof Level IP67
Power Source Lithium Metal battery, 1350 mAh capacity, 0.3 g
Temperature Accuracy ±0.5°C (-20°C to 60°C) and ±1.0°C (-40°C to -20°C)
Operating Range -40°C to 60°C
attery Life 3 years
Wireless Protocol Bluetooth v4.2
Transmit Power +8 dBm, FPC Antenna
Wireless Range 100 m (line of sight)
Certifications & Approvals
CE, FCC, UN38.3
Mounting Options 3M adhesive (included)

FCC Statement
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that
may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.