TLW vew K30-1260 User manual

Product Name: Dotless Sideview IP66 Rated LED Tape 12V 10W 144 LEDs Per Metre
Product Code: K30-1260
Kit Contents
LED flexible dotless strip light
3M Surface Prep Wipe
1 X Spare end cap
1 X Corner connector
1 X Small tube of silicone
Important Safety Information
This product is powered by an LED driver (supplied separately). The LED driver must be installed by
a qualified electrician.
Installation
1
2
3
Ensure the
surface is clean
and dust free
by using the 3M
surface prep
wipe. Allow 2
minutes for the
surface to dry.
If you need to
reduce the
length of the
strip, partially
peel back the
red tape on the
reverse of the
strip.
Cut the strip at
the indicated
cut points using
a pair of sharp
scissors.

Product Name: Dotless Sideview IP66 Rated LED Tape 12V 10W 144 LEDs Per Metre
Product Code: K30-1260
Installation
4
5
6
Using the
supplied
silicone, place a
small amount
inside the spare
end cap and fit
to the cut end
of the strip.
Peel back the
remaining red
tape and
install the LED
strip as
desired.
Plug the
power lead
into the
connector
block on the
LED driver.