Brightz CoolerBrightz User manual

Page 1of 2
CoolerBrightz™
Instructions
©
Copyright Brightz, Ltd. 2020
Patent Pending
IMPORTANT BATTERY INFORMATION:
CoolerBrightz™includes 2x CR2050 (3V) batteries.
Step 1– Operation
To operate CoolerBrightzTM, Press top center of CoolerBrightzTM to turn on and
start color changing. Press top center again to stop on desired color. To turn off
CoolerBrightzTM press top center again after color stop.
* CoolerBrightzTM will automatically turn off after 3 hours to conserve battery.
Step 2 – Installation
CoolerBrightz™ is water resistant and looks best when placed within, or underneath
ice, providing an awesome glow.
The easiest method:
1. Add a layer of ice to fill the bottom half of the cooler.
2. Position CoolerBrightzTM on top of the ice. CoolerBrightzTM is
water resistant and can be mixed within the ice.
3. Add bottles and/or cans.
4. Add remaining ice.

Brightz, Ltd.
8000 Yankee Road, Suite 225, Ottawa Lake, MI 49267 Email:
[e-mail]
Visit usatwww.brightz-ltd.com for more fun products!
Page 2of 2
Do not mix old and new batteries and do not mix alkaline, standard (carbon-zinc) or
rechargeable (nicad, ni-mh, etc.) batteries.
CHOKING HAZARD! – Small parts. Not for children 3 years of age or under.
WARNING! This product contains button or coin cell batteries. A swallowed button or coin
cell battery can cause internal chemical burns in as little as 2hours and can be fatal.
Properly dispose of used batteries according to local regulations. Keep new and used
batteries away from children. If you think batteries might have been swallowed or place
inside any part of the body, seek immediate medical attention.
CoolerBrightzTM is not intended for use in drink, and drink dispensing coolers or any
beverage dispensing system.
Step 3 – Battery Replacement of CoolerBrightzTM
Remove top cap. Then remove LED module and slide batteries from LED module to
remove noting polarity.
Replace new batteries by sliding batteries into LED module. Re-install LED module in
CoolerBrightzTM, and replace top cap.