Tokenworks CardVisor ID User manual

CardVisor®ID Scanner Quick Start Guide
See the Hardware User Manual for more information on using the ID Scanner and
the Software User Manual for how to transfer data to a PC.
1. Install fresh alkaline batteries into the
HandspringVisor handheld. Palm Logo should
appear on the screen in 2-3 seconds. If not, see
troubleshooting guide in Hardware User Manual.
2. Using the Stylus, follow on screen prompts to
center digitizer by tapping on the ‘X’s displayed on
screen, continue and then tap on the dotted box
around the displayed date and/or time. This will
launch a menus/calendars to adjust current time.
Date/Time must be correct for proper operation.
3. Insert the CardTool® magnetic card reader into the expansion slot of the Visor.
4. The CardVisor®Age Verification application will
auto-load a Welcome screen - Press the Date Book
button to launch ID Scanner. The DateBook key is
the bottom left round button with “1” printed on it.
“Swipe-A-Card” should display at the bottom of the
main screen.
5. Swipe a driver’s license and review main screen display.
(Bar Code Customer Continue on Next Page)

SEPTEMBER 2005 IM-120905-CWC-R1 PAGE 2 OF 2
6. Place ID Scanner
into Bar Code
Reader Cradle.
7. Secure with Tie
Down Cable
8. Press the
“Address” button
to Scan a 2D Bar
Code license.
”Scan -A-Card”
should display at
the bottom of
the main screen.
Wait for 3 beeps,
insert a licenses
and withdraw.
Display will
update