TOOL WAREHOUSE ZD07502Q User manual

DISASSEMBLE DRAWING
50 TON SHOP PRESS
RETAIN THIS MANUAL FOR FUTURE REFERENCE
PLEASE READ THIS MANUAL CAREFULLY BEFORE USE
ZD07502Q

PARAMETER
CAPACITY………………… 50 TON
WORKING RANGE……………0-1040 MM
WIDTH…………………… 615 MM
FEATURE
1. Used for parts straightening, bending and pressing.
2. Multi-position bed for work height adjustment.
3. With air pump can reduce labor and improve working efficiency
OPERATION
1. Place work piece on bed frame.
2. Locate and close release valve.
3. Pump handle until the ram nears work piece.
4. Apply load to work piece by pumping handle. Do not overload work piece.
5. Remove load from work piece by turning release valve. Stabilize work piece so it does not fall
while pressure is released.
6. Remove work piece after ram is fully retracted.
WARNING
1. This press is designed and intended for use by properly trained and experienced personnel
only. If you are not familiar with the proper and safe operation of a hydraulic press, do not use
until proper training and knowledge has been obtained.
2. Do not operate this press beyond it rated capacity.
3. DO NOT compress springs or other objects that could be ejected from the press. DO NOT
compress objects that could shatter.
4. Please understand the max. working stroke before operate, Do not overload the max.
working stroke, so as not to damage parts.
5. Check the press for loose or damaged parts before each operation. Replace damaged parts
and tighten all loose bolts before operating.
6. Some parts being pressed may have a tendency to pop out of the press or explode under
pressure. Protect yourself accordingly.
MAINTENANCE
1. Periodically, lightly oil all moving parts including the pump piston and hydraulic ram.
2. Check hydraulic connections and hoses before each use. Do not use if cut, damaged, leaking
or otherwise damaged connections and/or hoses are noted.
PARTS LIST
Part
No.
Description
Qty
Part
No.
Description
Qty
1
Bolt
6
19
Handle
1
2
Cross beam
1
20
Adjust beam
1
3
Damping nut M16
4
21
Abor plate
2
4
Spring washer 22
8
22
Pressure gauge
1
5
Washer M22
14
23
Jack
1
6
Damping nut M22
8
24
Bole
4
7
Pole
2
25
Washer M16
8
8
Pin
2
26
Gear
1
9
Tighter the scres
4
27
Gear seat
1
10
Washer M12
38
28
Damping nut M10
5
11
Bolt
12
29
Bolt
2
12
Leg
2
30
Steel wire
1
13
Damping nut M12
20
31
Collet
2
14
Connect boart
2
32
Steel shaft
4
15
Bolt
7
33
Steel wheel
4
16
Washer M10
14
34
Washer M18
4
17
Bolt
6
35
Block loop
4
18
Pump
1