Toppro AVANTI 15A User manual

AVANTI 15A
AVANTI
AVANTI

2
AVANTI AVANTI
15

INTRODUCTION
WIRE CONNECTIONS
FREQUENCY RESPONSE DIAGRAM
PANEL DESCRIPTION
7
RIGGING
6
WARRANTY
12
TECHNICAL SPECIFICATIONS
11
INDEX
10
4
9
QUICK START 5
3
* AVANTI 15A are Active Speakers for professional use, they can be used in following
electromagnetic environment: residential, commercial and light industrial, urban outdoors.
They are the apparatus Not intended for rack mounting.
* For AVANTI 15A, the peak inrush current is 0.9A
*This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1)this device may not cause harmful interference, and (2)this device must
accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
AVANTIAVANTI
14

AVANTI
AVANTI
4
AVANTI AVANTI
13

4
Quick Start
Make all initial connections with all the equipments powered off, and ensure that all the main
volume controls are turned completely down.
1). Connect one side of the signal cable at your audio mixer into output left / right (with Stereo-
speaker cabinet.
Jack or XLR) and the other side of the cable into the line input Stereo-Jack) of your active
2). Connect the power cord to mains.
3). Turn on your mixer first, then the active speaker cabinets.
4). Turn up the volume control of the active speaker cabinets.
5). Use PFL function to get the proper input level for the mixer, and adjust the
main mix level control to manipulate the output level.
6). After using, turn off your active speaker cabinets first, then the mixer.
Power Cord
Tripod
Mount
Left
Main Mix
Output
Signal Cable
Mixer
Power Cord
Tripod
Mount
Right
Output
Main Mix
Signal Cable
BALOR
UNBAL
BALOR
UNBAL
BALOR
UNBAL
LINEIN1
BALOR
UNBAL
LINEIN3LINE IN 2 LINEIN4
LEFT
LEFT(MONO)
RIGHT
STEREOAUXRETURNS
2
1
RIGHT
LINE
MIC
+15dB -25dB
0dB 40dB
LINE
MIC
+15dB -25dB
0dB 40dB
LINE
MIC
+15dB -25dB
0dB 40dB
LINE
MIC
+15dB -25dB
0dB 40dB
LOWCUT
75Hz18dB/Oct
LOWCUT
75Hz18dB/Oct
LOWCUT
75Hz18dB/Oct
LOWCUT
75Hz18dB/Oct
LINEIN5/6 LINEIN9/10 LINEIN11/12LINEIN7/8 AUXSENDS
1
+4dBu
-10dBV
+4dBu
-10dBV
+4dBu
-10dBV
+4dBu
-10dBV PHONE
LEFT(MONO) LEFT(MONO) LEFT(MONO)
RIGHT RIGHT RIGHT RIGHT
LEFT(MONO)
2
AUXRTN1
8
-
0
+15+15
2
AUXRTN2
MID
0
+15-15
8
-
0
+15
AUXSENDS
2
8
-
0
+15
SOLO
ACTIVE
SOLOMODE
LEVEL
SET
PFL
AFL
MUTE/
ALT3-4
SOLO
MUTE/
ALT3-4
SOLO
MUTE/
ALT3-4
SOLO
MUTE/
ALT3-4
SOLO
MUTE/
ALT3-4
SOLO
MUTE/
ALT3-4
SOLO
MUTE/
ALT3-4
SOLO
MUTE/
ALT3-4
SOLO
-2
0
-4
-7
-10
-20
+2
-30
OUTPUTLEVEL
LR
ALT3-4
2TK/USB
CLIP
+10
+7
+4
2TK/USB
ASSIGN
TOMIX
1
PWR
PHANTOM
MAINMIX
ALT3-4
CTRROOM
SOURCE
+15+15
PHONES
CONTROLROOM
12-CHANNELMIXING CONSOLE
WITH
DIGITALEFFECTS
12-CHANNELMIXING CONSOLE
WITH
DIGITALEFFECTS
MIC1 MIC2 MIC3 MIC4
HI
12kHz
EQ
+15
0
-15
HI
12kHz
EQ
+15
0
-15
HI
12kHz
EQ
+15+15
0
-15-15
HI
12kHz
EQ
+15+15
0
-15
HI
12kHz
EQ
+15
0
-15
HI
12kHz
EQ
+15+15
0
-15-15
HI
12kHz
EQ
+15
0
-15-15
HI
12kHz
EQ
+15
0
-15
FREQ
100Hz100Hz 8kHz
800
PAN
LR
R
PAN
LR
R
PAN
LR
R
PAN
LR
RLR RLR RLR R
BAL
LR
R
LOW
80Hz
0
+15-15
LOW
80Hz
0
+15-15-15
LOW
80Hz
0
+15-15
LOW
80Hz
0
+15-15
LOW
80Hz
0
+15-15
LOW
80Hz
0
+15-15-15
LOW
80Hz
0
+15-15
LOW
80Hz
0
+15-15
10
+15
8
-
MID
0
+15-15-15
MID
0
+15-15
HI-MID
3kHz
0
+15-15
HI-MID
3kHz
0
+15+15-15-15
HI-MID
3kHz
0
+15-15
HI-MID
3kHz
0
+15-15-15
FREQ
100Hz100Hz 8kHz
800
FREQ
100Hz100Hz 8kHz
800
MID-LO
500Hz
+15-15
00
MID-LO
500Hz
+15-15
00
MID-LO
500Hz
+15-15
00
MID-LO
500Hz
+15-15
00
AUX
1
PRE
POST
0
+15
8
-
AUX
1
PRE
POST
0
+15
8
-
AUX
1
PRE
POST
0
+15
8
-
AUX
1
PRE
POST
0
+15
8
-
AUX
1
PRE
POST
0
+15
8
-
AUX
1
PRE
POST
0
+15+15
8
-
AUX
1
PRE
POST
0
+15
8
-
AUX
1
PRE
POST
0
+15
8
-
2
POST
(PRE)
8
-
0
+15
DFX
2
POST
(PRE)
8
-
0
+15
DFX
2
POST
(PRE)
8
-
0
+15
DFX
2
POST
(PRE)
8
-
0
+15
DFX
2
POST
(PRE)
8
-
0
+15
DFX
2
POST
(PRE)
8
-
0
+15
DFX
2
POST
(PRE)
8
-
0
+15
DFX
2
POST
(PRE)
8
-
0
+15
DFX
MID
0
+15+15-15
FREQ
100Hz 8kHz8kHz
800
DFXMUTE
PEAK/MUTE
PROGRAM(PUSH)
00-09Echo
10-19Echo+Verb
20-29Tremolo
30-39Plate
40-49Chorus
50-59Vocal
60-69Rotary
70-79SmallRoom
80-89Flange+Verb
90-99LargeHall
DFX
BALBALBAL
8
-
MAINMIX
LEVEL
PEAK
10
dB
-5
-10
-15
-20
-30
-40
-60
0
5
PEAK
10
dB
-5
-10
-15
-20
-30
-40
-60
0
5
PEAK
10
dB
-5
-10
-15
-20
-30
-40
-60
0
5
PEAK
10
dB
-5
-10
-15
-20
-30
-40
-60
0
5
PEAK
10
dB
-5
-10
-15
-20
-30
-40
-60
0
5
PEAK
10
dB
-5
-10
-15
-20
-30
-40
-60
0
5
PEAK
10
dB
-5
-10
-15
-20
-30
-40
-60
0
5
PEAK
10
dB
-5
-10
-15
-20
-30
-40
-60
0
5
10
dB
-5
-10
-15
-20
-30
-40
-60
0
5
10
dB
-5
-10
-15
-20
-30
-40
-60
0
5
10
dB
-5
-10
-15
-20
-30
-40
-60
0
5
234 1ALT3-4
5/6 7/8 9/10 11/12
RIGHT
LEFT
2TK/USB
MUSIC PLAYER
88
00
03:08
MP3 USBREP ALL
AVANTI
5
11
AVANTI
12

5
The floor use is as a function of a monitor when the angle is 45
o
45o
Rigging
The AVANTI series speaker cabinet also provides the suspension points for installation.
(M10 1.5PH LENGTH: 30mm).
For further details, please refer to the right illustration(OPTIONAL FUNCTIONAL)
Suspension Point
Eye bolt
AVANTI
6
Technical Specifications
2-Way Active Vented Speaker
15" Woofer, 2"voice coil
1" NEO Driver, 1" Voice Coil
90Hx45V
oo
55Hz-20KHz
2.5K Hz
117dB Max.
Class D SMPS ( Bi-AMP , LF 90W/RMS + HF 30W/RMS),
250W Program power
With USB&Mirco SD CARD Bluetooth,
INPUT1-Mic With XLR*1&6.3 Jack*1/INPUT2-Line
With XLR*1&6.3Jack*1&3.5Jack*1
Input 1&2 and Master Volume Control/2 Band EQ-High&Low/
Power ON with Green LED/Clip Limiter with Red LED
Thermal/Overload/Analog limiter/Compressor
110~120 /220~240V~50 /60Hz swtichable
Plastic cabinet,Trapezoidal & Monitor shape,Metal grille, Rubber foot,
3* Handles ( both side and Top)
36MM standard pole-mount/ M10*4PCS Flying Pointing(Optional)
632*386*366 mm
14.37(kg)
5.35CFT
Model Active
System Type
Transducer Low
Transducer Driver
Horn Coverage H x V
Frequency Response (-6dB)
Crossover Frequency
Max SPL
Power Rating
USB Player
Connector
External Controls
Electronic Protections
Power Supply
Enclosure Construction
Mounting
Dimensions (HxWxD)
Net Weight
Volume
AVANTI 15A
10
AVANTI
11

(1) BI-POLAR MAIN POWER SWITCH
(2) AC POWER SOCKET WITH MAIN FUSE
(3) LINE INPUT ON XLR CONNECTOR
(4) MIC INPUT ON XLR CONNECTOR
(5) MIC INPUT ON 1/4 JACK CONNECTOR
(6) LINE INPUT ON 1/4 JACK CONNECTOR
(7) MIC INPUT VOLUME CONTROL
(8) LINE INPUT VOLUME CONTROL
(9) MASTER VOLUME CONTROL
(10) EQ-HIGH CONTROL
(11) LINE INPUT ON AUX CONNECTOR
(12) EQ-LOW CONTROL
(13) CLIP INDICATOR RED LED
(14) POWER INDICATOR GREEN LED
(15) MIX OUT ON XLR CONNECTOR
AMP INTERFACE
Panel Description
6
(1) (2)
AVANTI 15A
(7)
(5)
(4)
(6) (12)
(13)
(15)
(14)
(11)
(10)
(9)(8)
Useonly with a 250V fuse
(3)
AVANTI
7
9
AVANTI
10

Panel Description
7
(a) Insert a standard microSD card
(b) Insert USB player
(c) Aux Input
(d) Play the last song or decrease the volume after pressing 2 seconds
(e) Press this key to start playing or Press this key to pause
(f) Play the next song or increase the volume after pressing 2 seconds
(g) PLAY MODE
In the opening or playing state, press this key to select the three circling modes in order:
Line: The player plays the files you input. The mark on the screen is "LINE".
Bluetooth: The player plays the files from your bluetooth device The mark on the
screen is "BT"
USB : The player plays the files in a standard USB drive.The mark on the
screen is "USB"
(h) Display the status of USB playing
USB PLAYER
(1) (2)
AVANTI 15A
(7)
(5)
(4)
(6) (12)
(13)
(15)
(14)
(11)
(10)
(9)
(8)
Useonly with a 250V fuse
(3)
(g)
(f)
(e)
(d)
(c)
(b)
(h)
()a
AVANTI
8
8
AVANTI 15A
AVANTI
9