Topway 19YX01 User manual

19YX01 enter pairing mode automatically after power
on “Pairing”
TBD : battery low
press and hold the MFB button for 1s
incoming call（twice）+number notice one
time+incoming call
plug the 3.5mm audio
cable into to play music
plug the USB cable to
charge, the speaker
won't be power off
answer call (click)
can reconnect automatically if they connected
before or when beyond the operating range not
longer than 1 min and back to operating range
again
beyond operating range “disconnected”
2S
1S
Powering on
power off
connect
incoming call
17LY86
1
1
volume+ (press and hold)
3
previous song (click)
4
next song (click)
3
volume- (press and hold)
4
hang up call (click)
1
inject call (press and hold)
1
redial the last number ( double click)
1
cancel dial (click)
1play/pause (click) 1
24 3
60X80MM

FCC Requirement
changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator & your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.