Toshiba 24W1334G Quick start guide

Copyright 2013 All Rights Reserved Page 1of 4
NOTE; PERSONAL AND CUSTOM PREFRERENCES WILL BE LOST UPON COMPLETION
OF THIS FIRMWARE UPDATE. PLAEAE MAKE NOTE OF ANY PREFERENCE SETTINGS
PRIOR TO STARTING THIS FIRMWRE UPDATE.
How to upgrade the Software
1 Connect the AC power and turn “ON” the TV receiver.
2 The USB reader is located on the left of the cabinet near the side control/jack assembly as shown in
Figure1.
Figure1

Copyright 2013 All Rights Reserved Page 2of 4
3 Insert the “USB Drive” into the USB slot as shown in Figure2.
Figure2
4 After insertion of USB Drive into reader slot a Media Browser information window will appear as
shown in Figure3.
Figure3
5 If the window is no present, remove the USB Drive and try reinserting the USB Drive again.
6 Press “Menu”button of the remote controller to exit the “Media Browser”information.
7 Press the button on the remote controller in the sequence of “MENU”, “1”,”5”,”0”and ”5”.

Copyright 2013 All Rights Reserved Page 3of 4
8 The software upgrading menu will appear as shown Figure4.
Figure4
9 Press “OK” button of the remote controller to begin the upgrade.
10 The software upgrading process will begin. During the software upgrade, the TV receiver will
display “Software upgrade” as shown in Figure5.
During this time, do not remove power to the television or press any remote keys or buttons
on the television until the upgrade is complete!
Figure5
11 Upon completion, the TV will reboot automatically
12 Remove the “USB Drive” from the reader slot.
Do you want to update software ?
Yes No
Software upgrade
Downloarding : 56 persent

Copyright 2013 All Rights Reserved Page 4of 4
13 Press “MENU”button on the remote controller and select “Install and Retune”by using “Left”or
“Right”button to perform the “First time installation”function.
Press “OK”button and the following menu screen will be displayed as showing figure6.
Figure6
Select “First time installation”by using “Up”or “Down”button and press “OK”button.
“Do you want to delete all channels and setting for first time installation?”will be displayed.
Select “Yes”and press “OK”button.
“First time installation”will be displayed as shown figure7.
Figure7
Follow the instructions on the screen and consult the owners manual for the first time installation.
14 The TV upgrade is now complete.