TOTALINE Smart P330-0110 User manual

Totaline® Smart 1H/1C and 2H/2C
Non-Programmable P330 Series Thermostat
570-211
Operating
Manual
69-2263EFS-01
®

ENGLISH
Read and save these instructions.
® U.S. Registered Trademark. Patents pending.
All rights reserved.
Need Help?
Visit www.Totaline.com.
This manual covers the following models:
P330-0110: For 1 Heat/1 Cool systems
P330-0220: For up to 2 Heat/2 Cool systems
M27938

P330 Series
570-211 1 69-2263EFS—01
ENGLISH
About your new thermostat
Quick reference to controls.......................2
Quick reference to display ........................3
Programming & Operation
Fan setting (auto/on)..................................4
System setting (heat/cool/auto)................5
Auto-changeover (heat/cool).....................6
Compressor protection..............................7
Appendices
Battery replacement ..................................8
Troubleshooting .........................................9
Customer assistance ............................... 11
Accessories/replacement parts .............. 11
Warranty ...................................................12
Table of contents
CAUTION: EQUIPMENT DAMAGE
HAZARD. To prevent possible
compressor damage, do not operate
cooling system when outdoor
temperature is below 50°F (10°C).

Operating Manual
69-2263EFS—01 2 570-211
ENGLISH
M27938
Digital display (see page 3)
Temperature Buttons
Press to set preferred
temperature.
Function Buttons
Press to select the function displayed
just above each button. (Functions
change depending on the task.)
Quick reference to controls

P330 Series
570-211 3 69-2263EFS—01
ENGLISH
M27858
Current inside
temperature
Function buttons
Press the button beneath each function to view or change
settings (functions change depending on the task)
Low battery warning
(see page 8)
Temperature
setting
System status
Heat /Cool
(If flashing, see page 7)
System setting
Heat/Cool/Auto/Off/
Em Heat (see page 5)
Fan setting
Auto/On (see page 4)
Quick reference to display screen
Auxiliary heat (Only
for heat pumps with
auxiliary heat)

Operating Manual
69-2263EFS—01 4 570-211
ENGLISH
Press the FAN button to select Auto or On.
In “Auto” mode (the most commonly used
setting), the fan runs only when the heating
or cooling system is on. If set to “On,” the fan
runs continuously.
Select the fan setting
Note: The Fan settings might
not appear, depending on how
your thermostat was installed.
M27859
M27860

P330 Series
570-211 5 69-2263EFS—01
ENGLISH
Press the SYSTEM button to select:
• Heat: Thermostat controls only the
heating system.
• Cool: Thermostat controls only the
cooling system.
• Off: Heating and cooling systems are off.
• Auto: Thermostat automatically selects
heating or cooling depending on the
indoor temperature.
• Em Heat (only for heat pumps with
auxiliary heat): Thermostat controls
Emergency and Auxiliary Heat.
Compressor is locked out.
Select the system setting
Note: The Auto, Em Heat or
Cool system settings may not
appear, depending on how
your thermostat was installed.
M27859
M27862

Operating Manual
69-2263EFS—01 6 570-211
ENGLISH
Auto Changeover is a feature used in climates
where both air conditioning and heating are
used on the same day. When the system is set
to Auto, the thermostat automatically selects
heating or cooling depending on the indoor
temperature.
Heat and cool settings must be at least 3
degrees apart. The thermostat will automati-
cally adjust settings to maintain this 3-degree
separation (called “deadband”).
The 3-degree separation between heating and
cooling set temperatures is fixed, and cannot
be changed.
Auto Changeover (heat/cool)
Press until screen
displays “Auto”
Note: The Auto system setting
may not appear, depending on
how your thermostat was installed.
M27863

P330 Series
570-211 7 69-2263EFS—01
ENGLISH
Message flashes until safe
restart time has elapsed
M27864
This feature helps prevent damage to the
compressor in your air conditioning or heat
pump system.
Damage can occur if the compressor is
restarted too soon after shutdown. This fea-
ture forces the compressor to wait for a few
minutes before restarting.
During the wait time, the display will flash the
message Cool (or Heat if you have a heat
pump). When the safe wait time has elapsed,
the message stops flashing and the compres-
sor turns on.
Built-in compressor protection

Operating Manual
69-2263EFS—01 8 570-211
ENGLISH
Batteries are optional (to provide backup
power) if your thermostat was wired to run on
AC power when installed.
Install fresh batteries immediately when the
warning begins flashing. The warn-
ing flashes about two months before the bat-
teries are depleted.
Even if the warning does not appear, you
should replace batteries once a year, or before
leaving home for more than a month.
Batteries provide backup power to the display
during power interruptions. All settings are
permanently stored in memory, and do not
require battery power.
Battery Replacement
Insert fresh alkaline batteries.
P330-0110–AAA alkaline batteries.
P330-0220–AA alkaline batteries.
+
+
M27946

P330 Series
570-211 9 69-2263EFS—01
ENGLISH
Troubleshooting
If you have difficulty with your thermostat, please try the following suggestions.
Display is blank • Checkcircuitbreakerandresetifnecessary.
• Makesurepowerswitchatheating&coolingsystemison.
• Makesurefurnacedoorisclosedsecurely.
• Ifthermostatisbattery-powered,makesurefreshAAorAAAalkaline
batteries (depending on model) are correctly installed (see page 8).
Temperature
settings do not
change
Make sure heating and cooling temperatures are set to acceptable ranges:
• Heat:40°to90°F(4.5°to32°C).
• Cool:50°to99°F(10°to37°C).

Operating Manual
69-2263EFS—01 10 570-211
ENGLISH
Troubleshooting
Heating or
cooling system
does not respond
• Press SYSTEM button to set system to Heat . Make sure the temperature
is set higher than the Inside temperature.
• PressSYSTEM button to set system to Cool . Make sure the
temperature is set lower than the Inside temperature.
• Checkcircuitbreakerandresetifnecessary.
• Makesurepowerswitchatheating&coolingsystemison.
• Makesurefurnacedoorisclosedsecurely.
• Wait5minutesforthesystemtorespond.
“Cool ” or
“Heat ”
is flashing
•Compressor protection feature is engaged. Wait 5 minutes for the system
to restart safely, without damage to the compressor (see page 7).

P330 Series
570-211 11 69-2263EFS—01
ENGLISH
Customer assistance
Visit www.Totaline.com.
Accessories/replacement parts
Contact your heating/cooling contractor for replacement parts.
P330-0110
Cover plate assembly* .... Part No. P350-CP-R330NP
P330-0220
Cover plate assembly* ....... Part No. P350-CP-MULTI
*Use to cover marks left by old thermostats.

Operating Manual
69-2263EFS—01 12 570-211
ENGLISH
Limited Five-Year Warranty
FIVE-YEAR WARRANTY—This CARRIER CORPORATION product is warranted to be free from defects in
material and workmanship under normal use and maintenance for a period of five years from the date of
original installation. A new or remanufactured part to replace the defective part will be provided without
charge for the part itself, through a qualified servicing CARRIER CORPORATION dealer or service, provided
the defective part is returned to our distributor. The replacement part assumes the unused portion of the
warranty.
THIS WARRANTY DOES NOT INCLUDE ANY ADDITIONAL LABOR ALLOWANCE OR OTHER COSTS incurred
for diagnosis, repairing, removing, installing, shipping, servicing, or handling of either defective parts or
replacement parts. SUCH COSTS MAY BE COVERED BY a separate warranty provided by the installer.
LIMITATIONS OF WARRANTIES—ALL IMPLIED WARRANTIES (INCLUDING IMPLIED WARRANTIES OF
MERCHANTABILITY) ARE HEREBY LIMITED IN DURATION TO THE PERIOD FOR WHICH THE LIMITED
WARRANTY IS GIVEN. THE EXPRESSED WARRANTIES MADE IN THIS WARRANTY ARE EXCLUSIVE AND
MAY NOT BE ALTERED, ENLARGED, OR CHANGED BY ANY DISTRIBUTOR, DEALER, OR OTHER PERSON
WHATSOEVER.
CARRIER WILL NOT BE RESPONSIBLE FOR:
1. Normal maintenance as outlined in the installation and servicing instructions or owner’s manual.
2. Damage or repairs required as a consequence of faulty installation or application by others.
3. Failure to start due to voltage conditions, blown fuses, open circuit breakers or other damages due to the
inadequacy or interruption of electrical service.

P330 Series
570-211 13 69-2263EFS—01
ENGLISH
Limited Five-Year Warranty
4. Damage or repairs needed as a consequence of any misapplication, abuse, improper servicing,
unauthorized alteration, or improper operations.
5. Damage as a result of floods, winds, fires, lightning, accidents, corrosive atmosphere, or other conditions
beyond the control of CARRIER CORPORATION.
6. Parts not supplied or designated by CARRIER CORPORATION.
7. CARRIER CORPORATION products installed outside the continental U.S.A., Alaska, Hawaii, and Canada.
8. Electricity or fuel costs or increases in electricity or fuel costs from any reason whatsoever including
additional or unusual use of supplemental heat.
9. ANY SPECIAL INDIRECT OR CONSEQUENTIAL PROPERTY OR COMMERCIAL DAMAGE OF ANY NATURE
WHATSOEVER. Some states do not allow the exclusion of incidental or consequential damages, so the
above limitation may not apply to you.
Model No. Unit Serial No.
Date of Installation Installed by
Name of Owner Address of Installation

570-211
69-2263EFS—01 M.S. 11-08
Printed in U.S.A. on recycled
paper containing at least 10%
post-consumer paper fibers.

Totaline® Smart 1C/1F et 2C/2F
Thermostat non programmable série P330
570-211
Manuel
d’utilisation
®

FRANÇAIS
Lire et conserver ces instructions.
® Marque déposée aux É.-U. Brevets en instance.
Tous droits réservés.
Besoin d’aide?
Consulter le www.Totaline.com.
Ce guide couvre les modèles suivants :
P330-0110 : Pour 1 système de chauffage
et 1 système de climatisation
P330-0220 : Pour 2 systèmes de chauffage
et 2 systèmes de climatisation
M27938

570-211 17 69-2263EFS—01
FRANÇAIS
Série P330
À propos du thermostat
Consultation rapide des commandes.....18
Consultation rapide de l’écran................19
Programmation et fonctionnement
Réglage de la soufflante (Auto/On).........20
Réglage du système (Heat/Cool/Auto) ...21
Substitition automatique (Heat/Cool) .....22
Protection du compresseur.....................23
Annexes
Remplacement des piles......................... 24
Dépannage ............................................... 25
Assistance à la clientèle..........................27
Accessoires et pièces de rechange........ 27
Garantie....................................................28
Table des matières
MISE EN GARDE : RISQUE DE
DOMMAGES AU MATÉRIEL. Pour
prévenir des dommages potentiels au
compresseur, ne pas faire fonctionner
le système de climatisation lorsque
la température extérieure est inférieure
à 10 °C (50 °F).

69-2263EFS—01 18 570-211
FRANÇAIS
Manuel d’utilisation
M27938
Affichage numérique (page 19)
Boutons de température
Appuyer pour régler
la température voulue.
Boutons de fonctions Appuyez
pour sélectionner la fonction
indiquée au-dessus de chaque
bouton. (Les fonctions changent
selon la tâche.)
Consultation rapide des commandes