Toto EGO II TX443SESN User manual

SPECIFICATIONS
S06255S
"EGO II" SINGLE LEVER SHOWER MIXER TX443SESN
Ø162
70
500
-20
115
WALL
G½
G½ G½
700
-20
TROUBLESHOOTING
CHECK
POINT
Water leaks around the handle 1 Tighten
Handle is loose 2 Tighten
PROBLEM
SOLUTION
2. BOLT
1. CONNECTING NUT
R9
INSTALLATION
1.
3.
2.
Handle
Bolt
Cover *
Mortar
Flange
* Remove the cover after the mortar has dry
Cold Water
Supply *
Hot Water
Supply * ToShower Head *
Hex.
Key
Packing
* Pipe supplied by owner
Minimal
Mortar Level
Maximal
Mortar Level
Bolt
Ring w/ O-Ring
Cap
OPERATING CONDITIONS
MAINTENANCE
ATTENTION
1. Water supply pressure : 0.05 ~ 0.75MPa.
2. Ensure that water supply is clean ( No Sand, Dirt, Etc.).
1.Don t use abrasive cleaners or solvents on faucets and
fittings.
As the product model is constantly updated, the actual
product may not look the same as it shown in the diagram,
but the basic installation principles are the same.
2.
All Finishes : Clean the finish with mild soap and warm
water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as
ammonia, chlorine, toilet cleaner etc. which could adversely
affect the finish and are not recommended for cleaning

SPESIFIKASI
S06255S
"EGO II" SINGLE LEVER SHOWER MIXER TX443SESN
PENYELESAIAN MASALAH
Air bocor disekitar handle 1 Kencangkan
Handle longgar 2 Kencangkan
MASALAH
SOLUSI
POIN
PERIKSA
2. BOLT
1. CONNECTING NUT
R9
PEMASANGAN
1.
3.
2.
Handle
Bolt
Cover *
Mortar
Flange
* Lepas cover setelah mortar mengering
Cold Water
Supply *
Hot Water
Supply * ToShower Head *
Hex.
Key
Packing
* Pipa disediakan oleh pemilik
Minimal
Mortar Level
Maximal
Mortar Level
Bolt
Ring w/ O-Ring
Cap
KONDISI OPERASIONAL
PEMELIHARAAN
PERHATIAN
1. Tekanan sumber air: 0.05 ~ 0.75 MPa.
2. Pastikan kondisi sumber air adalah bersih (tidak ada pasir,
kotoran dan lain lain)
1.Jangan gunakan pembersih atau pelarut abrasif pada
faucet dan fitting.
Karena model produk terus mengalami pembaharuan,
aktual produk mungkin tidak sama dengan gambar, tapi
prinsip dasar pemasangan adalah sama.
2.
Seluruh lapisan : Bersihkan lapisan akhir dengan sabun lembut
dan air hangat. Lap seluruh permukaan hingga benar-benar
kering dengan kain lembut yang bersih. Kebanyakan bahan
pembersih mungkin mengandung bahan kimia, seperti amonia,
klorin, pembersih toilet, dll. yang dapat mempengaruhi hasil
akhir dan tidak disarankan untuk dibersihkan
Ø162
70
500
-20
115
WALL
G½
G½ G½
700
-20