Touch Dynamic EC150 Installation instructions

TOUCH DYNAMIC INC.
EC150 monitor wall mount
installation
10/15/2012
Proprietary Note: The information contained in this document is confidential and proprietary to Touch Dynamic (TD) Inc. The document or the
information it contains is NOT to be used, reproduced, modified or disclosed outside of Touch Dynamic Inc. without the written permission of
Touch Dynamic Inc.

Package contents
Universal Mounting
Hardware kit
Wall plate
Monitor plate

Installation Instructions
1) Disconnect all the cables from the monitor I/O ports and remove the power supply. Place the
monitor on the flat secure surface
2) Remove 2 screws that secure the stand and remove the stand
3) Remove 2 screws from the hinge cover
Remove 2 screws
Remove 2 screws

4) Use the flat screw driver to pull the cover up and remove it
5) Remove 4 screws from the hinge plate.
Insert the flat screwdriver in
the opening and pull it up to
unclip the hinge cover.

6) Put the monitor plate (the hooks should face down) and secure it with 4 screws
Install the wall mount bracket at the desired location on the wall and put the system on. All 4
hooks must be engaged to ensure the correct mounting.
Please note: The installation might require special tools (e.g. hammer drill, screw gun, level)
and the understanding of the most common surface types (.e.g. sheetrock, concrete and
wood) to determine the best mounting hardware needed to secure the wall plate (e.g.
anchors for the concrete and sheetrock).
Secure the plate with 4 screws