TouchStar Nohmad Fingerprint User manual

SPECIFICATION:
Power:
Power:Power:
Power: Low power 5v DC mains
adaptor, 0.5W average
Dimensions:
Dimensions:Dimensions:
Dimensions: 165mm x 66mm x 50mm
Installation:
Installation:Installation:
Installation: 2 x o. 6 screws or adhesive pad
Media:
Media:Media:
Media: iButton™, Fingerprint, Mifare
Indicators:
Indicators:Indicators:
Indicators: 4 digit numeric display
Two single-colour LED status
indicators, Audible buzzer
SIM card:
SIM card:SIM card:
SIM card: Easy-install caged SIM
connector
Cellular radio:
Cellular radio:Cellular radio:
Cellular radio: Quad GSM band
(800/900/1800/1900 MHz)
Cellular data:
Cellular data:Cellular data:
Cellular data: GPRS class 10 (packet)
RF connection:
RF connection:RF connection:
RF connection: Built-in dual-band antenna
(900/1800 MHz)
External antenna connection and
optional high-gain external antenna
Processing:
Processing:Processing:
Processing: 104MHz, 32 bit ARM9 wireless
processor
Clock:
Clock:Clock:
Clock: Battery-backed Real Time Clock
with calendar
INDICATORS...The ohmad
ohmad ohmad
ohmad terminal is fitted with two LED sta-
tus indicators.
LH LED flashing Blue
LH LED flashing BlueLH LED flashing Blue
LH LED flashing Blue: Valid connection to the GSM network.
LH LED steady Blue
LH LED steady BlueLH LED steady Blue
LH LED steady Blue: Invalid connection to the GSM network.
RH LED off
RH LED offRH LED off
RH LED off: ormal operation, flashes once when media is read.
RH LED flashes repeatedly
RH LED flashes repeatedlyRH LED flashes repeatedly
RH LED flashes repeatedly: See table below:
REFERENCES...
......
...Other documentation and utilities will relate to
the ohmad
ohmad ohmad
ohmad depending on how it is being used:
For use with our Fastlane product MA 060
MA 060MA 060
MA 060-
--
-XX
XXXX
XX
MA 062
MA 062MA 062
MA 062-
--
-XX
XXXX
XX
For use with customer software SDK download
SDK downloadSDK download
SDK download
MA 050
MA 050MA 050
MA 050-
--
-XX
XXXX
XX
MA 051
MA 051MA 051
MA 051-
--
-XX
XXXX
XX
MA 052
MA 052MA 052
MA 052-
--
-XX
XXXX
XX
MA 058
MA 058MA 058
MA 058-
--
-XX
XXXX
XX
Nohmad GPRS Terminal Nohmad GPRS Terminal
IMPORTANT SAFETY INFORMATION...This terminal has been
designed to meet international safety standards but, like any electrical equipment,
care must be taken if safety is to be assured. read these safety instructions before
installation and operation of the terminal. Retain this installation guide for future
use.
DO
DODO
DO ensure that all the electrical connections (including
power connections and interconnections between
pieces of equipment) are properly made in accordance
with the manufacturers instructions. Equipment
Equipment Equipment
Equipment
provided with a safety earth connection must be
provided with a safety earth connection must be provided with a safety earth connection must be
provided with a safety earth connection must be
earthed
earthedearthed
earthed
DO
DODO
DO consult your dealer if you are in any doubt about
installation, operation or safety of the equipment
DO
DODO
DO remember that some equipment continues to
operate after mains power has been removed, because
of an internal battery. In such cases a qualified Service
Engineer must disconnect the battery before
attempting to service the equipment
DO OT
DO OTDO OT
DO OT continue to operate the equipment if you are
in any doubt about it working normally
DO OT
DO OTDO OT
DO OT remove any cover fastenings unless you are
suitably qualified to do so. Even then isolate from the
power connection before you start
DO OT
DO OTDO OT
DO OT allow the equipment to be exposed to rain or
moisture other than permitted by the equipment's
specification
DO OT
DO OTDO OT
DO OT attempt to service any battery fitted to the
equipment. If the battery fitted to the circuit board is
faulty, return the complete circuit board to an
approved Service Centre. Removable batteries may be
replaced by suitably qualified Personnel
WARNING...To comply with international safety standards the a.c. supply must
be routed via an easily accessible isolating device. This device must have a contact
gap of at least 3mm (three millimetres) and should break both Live and eutral
conductors simultaneously. If the eutral conductor can be reliably identified the
device may be in the Live conductor only.
POWER REQUIREMENT...The ohmad
ohmadohmad
ohmad Attendance Terminal is supplied
with an external low power 5v DC mains adaptor, 0.5W average.
56
NO: CONDITION ACTION
2
22
2 o TCP/IP connection
3
33
3 o GPRS connection
LH LED steady: Check signal strength
LH LED flashing: Check SIM/network pa-
rameters
4
44
4 Memory full, no TCP/IP
connection Check parameters and host server
5
55
5 Memory full, no GPRS con-
nection
LH LED steady: Check signal strength
LH LED flashing: Check SIM/network pa-
rameters
6
66
6 Memory full, connected, no
server response Check host software appli- cation
7
77
7 PI required Enter a correct PI
8
88
8 SIM fault Contact supplier
9
99
9 SIM fault Check SIM is fitted
10
1010
10 Memory full, connected,
faulty server response Check host software appli- cation
OHMAD GPRS TERMI AL
USER GUIDE
MAN0 1-04
SEPTEMBER 201
www.touchstar-atc.com
5 www.touchstar-atc.com

 BATTERY REPLACEMENT...
......
...If it is necessary to replace the
internal battery, turn the ohmad
ohmad ohmad
ohmad terminal off at the mains
first. Remove the front cover carefully remembering not to pull
the cable connecting the reading device to the circuit board.
Unplug this cable and then the power cable.
Undo and remove the 4 screws holding the circuit board to the
rear of the terminal. Turn the board upside down to reveal the
battery.
Remove the old battery and replace with the correct type
(CR2032, 3V Lithium). Re-assemble the ohmad
ohmad ohmad
ohmad terminal.
 EXTERNAL ANTENNA...
......
...To fit an external antenna, detach
the internal connection by unplugging it and then fit a suitable
external one. Please contact TouchStar for further information
on this.
INTRODUCTION...
......
...Thank you for purchasing the ohmad
ohmadohmad
ohmad ter-
minal. To ensure you get the best from this product, some
careful system configuration is required. Please take time to
read the setup notes fully below before proceeding.
CONTENTS...
......
...Carefully remove the contents and check that
everything is present before continuing. There should be 1 x
terminal, 1 x power supply, 1 x packet of fixing screws and ad-
hesive pads, 1 x user guide.
 PREPARATION...
......
...Before anything else can be carried out, the
ohmad
ohmad ohmad
ohmad GPRS terminal must be opened up by separating the
front case from the rear. Carefully undo the two screws hold-
ing them together making sure not to pull the cable connect-
ing the reading device on the front cover and it’s connection
to the circuit board whilst doing this.
The circuit board will be revealed. All connections are made to
this including the power supply, SIM card and backup battery
on the rear of the board.
 POWER SUPPLY CONNECTION...
......
...You need to attach the
power supply to the terminal at this stage so that the setup
procedure can continue.
PLEASE NOTE: Ensure the power supply is turned off before
connecting it to the ohmad
ohmadohmad
ohmad terminal. Push the connector into
place as shown.
The cable can be routed through the back of the terminal or
by the cut-out on the side of the case.
 SIM CARD FITTING...
......
...If not already fitted, remove the SIM
card carefully from the outer card making sure that you note
the PI and PUK number. On the ohmad
ohmadohmad
ohmad terminal locate the
SIM slot as indicated. Always observe normal good practices
when handling the SIM and avoid leaving fingerprints on the
gold contacts.
Insert the SIM card into the carrier ensuring correct orientation.
Ensure it fully seated.
PLEASE NOTE: It is likely that the ohmad
ohmad ohmad
ohmad terminal will al-
ready have the SIM card fitted if it has been Fastlane enabled.
For more information on our Fastlane cloud service see our
document MA 060
MA 060MA 060
MA 060-
--
-XX
XXXX
XX.
www.feedback-group.com
234
Nohmad GPRS Terminal Nohmad GPRS Terminal Nohmad GPRS Terminal
www.touchstar-atc.com
2 www.touchstar-atc.com 3 www.touchstar-atc.com 4