
Cover
Handle
ON/OFF Switch
Power base
Body
CLEANING
1. Before cleaning unplug the appliance. Allow it to cool down.
2. Wipe it inside and out with a soft cloth.
3. Descale your jug kettle regularly:
=Cover the heating elements with vinegar and water (2/3 water, 1/3 vinegar).
or change vinegar to lemon.
=Boil up the solution two or three times, take care that do not overflow.
=Rinse out the appliance and wipe with a soft cloth.
1 2
PART NAME
IMPORTANT SAFEGUARDS
1. Using electrical equipment can be dangerous. Please read the instructions
carefully before use.
2. The appliance is only to be used for the purposes described in these instructions.
3. Children do not realize the dangers associated with electrical appliances. Never
allow children to work with electrical equipment without supervision.
4. In the case of obvious damage to the appliance or the cable, consult an
electrician.
5. Repairs to electrical equipment may only be carried out by properly trained
person. Repairs, which are improperly carried out, can result in considerable
danger for user.
6. Use the appliance only on the voltage specified on the rating label.
7. The appliance gets hot during use. Touch only the handles or control knob.
8. Use only on a dry, anti-slip, level surface.
9. Do not fill to above the mark MAX, because there is danger that the boiling water
may overflow (danger of scalding!).
10. Never switch on the appliance when its lid is open.
11. Only suitable for pure water never put other liquids in the kettle jug.
12. Do not use outdoor.
13. Descale the kettle jug regularly .by using few pieces of lemon by boiling
14. After finish boiling water, please switch off the power supply, to avoid further
damage to the element.
BEFORE USING FOR THE FIRST TIMER
1. Important: please read the instructions carefully before use.
2. Remove all packing material.
3. Completely unroll the cable.
4. away the first lot of water after boiling.Dispose
BOILING WATER
1. Open the lid, fill the jug kettle, this can be done with the lid or via the large spout.
2. Completely unroll the cable.
3. Put the main body on cordless base.
4. Plug in the mains plug.
Warning: Appliance becomes hot during use.
5. Switch on the jug kettle, the indicator lamp will be on.
6. the water , the appliance switch off automatically.After is being boiled
7. Water can be poured out with the lid on.
8. The main body can easily be removed from its base.
9. Heating can be stopped at any time by operating the switch.
USING YOUR KETTLE
1. The appliance is only suitable for heating and boiling water.
2. Do not use any other liquids except pure water. The heating element must be
covered with water. Otherwise there is danger of dry heat.
3. Should the boil-dry protection operate, allow the jug kettle to cool down. The
appliance will be ready for use automatically.
CAUTION: Do not fill the kettle with water above the MAX water level mark. If you
do, hot water will overflow. Do not fill the kettle with water below the MIN water
level mark. If you do, the kettle will not operate normally.