Toyotomi HC-190 User manual

(over)
Mounting Instructions Wall Hung Bracket for model HC-190
Included with the Wall Hung Bracket are 4 #10
by 1/2” self-tapping screws and 4 #12 by 1 ¼”
screws with 4 white plastic Toggle™anchors
and one red plastic key.
First find a location on the wall where all
necessary plumbing and electric connections
can be made. On the Wall Hung Bracket there
are 4 screw holes for mounting to the wall.
(See arrows in Photo 1.) They are
located 16 inches apart. All 4 screw holes must be
used to anchor the Heat Convector to the wall.
*Wall Hung Bracket is not recommended for sheetrock or other materials less than 3/8” thick.
If the Wall Hung Bracket is to be mounted into studs then the Toggle™anchors are not needed.
If no stud is located behind the mounting location then Toggle™ anchors (included) are needed.
Hold Wall Hung Bracket to wall. Check that Wall Hung Bracket is level and mark holes to be drilled on
wall (see arrows above in Photo 1). Follow steps for Toggle™ anchors below.
1-Drill a 5/16" diameter hole. Fold anchor in middle.
2-Insert anchor in hole and tap flush.
3-Insert red plastic key to pop anchor open behind hollow wall (not
necessary for thick or solid walls). Do not hammer key. Remove key.
Photo 1

4-Place Wall Hung Bracket over anchor. Insert the #12 by 1 ¼” screw and
tighten until flush with bracket then stop. Do not over tighten. Check to
make sure Wall Hung Bracket is secured to wall.
2 Side Wall Bracket sets are included with Heat Convector (Photo 2
above shows 1 set). Using 2 of the #10 by 1/2” self-tapping screws,
attach 1 each of Part A of the Side Wall Bracket to the small holes
located at the top corners of the Wall Hung Brackett (see triangle
in Photo 1). Make sure Side Wall Brackets are turned
sideways and are facing out as shown in Photo 3.
Make all necessary plumbing and electric connections to Heat
Convector. Attach the remaining two pieces of the Side Wall Bracket
(Part B in Photo 2) to Heat Convector using the middle screw located on
the back of the Heat Convector. (See arrows on Photo 4)
Place Heat Convector onto Wall Hung
Bracket. Attach both pieces of Side Wall
Bracket (Part A & B above) together with
fine thread screws that comes with Side
Wall Brackets. Now use the other 2 #10
self-tapping screws and secure Heat
Convector to Wall Hung Bracket using
the small holes on the bottom front (big
arrows in Photo 1) of the Wall
Hung Bracket.
Check to make sure Heat Convector is
secure to Wall Hung Bracket.
Photo 4
Back of Heat Convector