TP-Link TL-R4199G User manual

TL-R4199G
SMB Broadband Router
Rev: 1.0.3
1910010054

COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice. is a registered trademark of
TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or
registered trademarks of their respective holders.
No part of the specifications may be reproduced in any form or by any means or used to make any
derivative such as translation, transformation, or adaptation without permission from TP-LINK
TECHNOLOGIES CO., LTD. Copyright © 2008 TP-LINK TECHNOLOGIES CO., LTD.
All rights reserved.
http://www.tp-link.com

FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio interference, in
which case the user may be required to take adequate measures.

Package contents
The following contents should be found in your box:
¾One TL-R4199G SMB Broadband Router
¾One power cord for TL-R4199G SMB Broadband Router
¾One Resource CD for TL-R4199G SMB Broadband Router, including:
•This Guide
•Other Helpful Information
¾Mounting kits for installing in a standard 19-inch rack
)Note:
Make sure that the package contains the above items. If any of the listed items are damaged or
missing, please contact with your distributor.
Conventions
The Router or TL-R4199G mentioned in this guide stands for TL-R4199G SMB Broadband Router
without any explanation.
Parameters provided in the pictures are just references for setting up the product, which may
differ from the actual situation.
You can set the parameters according to your demand.

CONTENTS
Chapter 1. Introduction ........................................................................................ 1
1.1 Overview of the Router .................................................................................................. 1
1.2 Features......................................................................................................................... 1
Chapter 2. Hardware installation ......................................................................... 2
2.1 Panel Layout.................................................................................................................. 2
2.1.1 The Front Panel................................................................................................................2
2.1.2 The Rear Panel ................................................................................................................3
2.2 System Requirements ................................................................................................... 3
2.3 Installation Environment Requirements ......................................................................... 3
2.4 Connecting the Router................................................................................................... 3
Chapter 3. Quick Installation Guide .................................................................... 5
3.1 Configure PC ................................................................................................................. 5
3.2 Login.............................................................................................................................. 8
Chapter 4. Configuring the Router .................................................................... 11
4.1 Status........................................................................................................................... 11
4.2 Quick Setup ................................................................................................................. 13
4.3 Network........................................................................................................................ 13
4.3.1 LAN.................................................................................................................................13
4.3.2 WAN ...............................................................................................................................14
4.3.3 Network service detection ..............................................................................................25
4.3.4 MAC Clone .....................................................................................................................25
4.3.5 WAN Port Parameter......................................................................................................26
4.4 DHCP........................................................................................................................... 27
4.4.1 DHCP Settings ...............................................................................................................28
4.4.2 DHCP Clients List...........................................................................................................29
4.4.3 Address Reservation ......................................................................................................29
4.5 Forwarding................................................................................................................... 30
4.5.1 Virtual Servers................................................................................................................31
4.5.2 Port Triggering................................................................................................................32
4.5.3 DMZ................................................................................................................................34
4.5.4 UPnP ..............................................................................................................................35
4.6 Security........................................................................................................................36
4.6.1 Firewall ...........................................................................................................................36
4.6.2 IP Filtering ......................................................................................................................37
4.6.3 Domain Filtering .............................................................................................................40
4.6.4 MAC Filtering..................................................................................................................41
4.6.5 Screen ............................................................................................................................43
4.7 Static Routing .............................................................................................................. 46
4.8 Session Limit ............................................................................................................... 48

4.8.1 Session Limit ..................................................................................................................48
4.8.2 Session List ....................................................................................................................49
4.9 QoS.............................................................................................................................. 49
4.9.1 QoS Settings ..................................................................................................................50
4.9.2 QoS Rules List ...............................................................................................................50
4.10 IP & MAC Binding ........................................................................................................ 51
4.10.1 Binding Setting ...............................................................................................................51
4.10.2 ARP List..........................................................................................................................53
4.11 Dynamic DNS .............................................................................................................. 54
4.11.1 Dyndns DDNS ................................................................................................................54
4.11.2 PeanutHull DDNS...........................................................................................................55
4.11.3 Comexe DDNS...............................................................................................................55
4.12 Switch Setting .............................................................................................................. 56
4.12.1 Port Statistics .................................................................................................................57
4.12.2 Port Mirror ......................................................................................................................57
4.12.3 Port Rate Control............................................................................................................58
4.12.4 Port Parameter ...............................................................................................................58
4.12.5 Port Status......................................................................................................................59
4.12.6 Port VLAN ......................................................................................................................60
4.13 System Tools ............................................................................................................... 60
4.13.1 Time Settings .................................................................................................................61
4.13.2 Firmware.........................................................................................................................62
4.13.3 Factory Defaults .............................................................................................................62
4.13.4 Backup and Restore.......................................................................................................63
4.13.5 Reboot............................................................................................................................64
4.13.6 Password........................................................................................................................65
4.13.7 System Log ....................................................................................................................66
4.13.8 Remote Management.....................................................................................................66
4.13.9 Statistics .........................................................................................................................67
4.13.10WAN Speed Detect ........................................................................................................68
4.13.11IP NAT Table..................................................................................................................70
4.13.12NAT Source Port Settings ..............................................................................................70
Appendix A: Specifications................................................................................... 71
Appendix B: FAQ.................................................................................................... 72
Appendix C: Glossary............................................................................................ 76

TL-R4199G SMB Broadband Router User Guide
1
Chapter 1.Introduction
Thank you for choosing TL-R4199G SMB Broadband Router!
1.1 Overview of the Router
The TL-R4199G SMB Broadband Router possesses excellent throughput and driving load
capability, which consumedly meets the requirements from Internet cafe and small
/medium/sizable enterprise with volumes of users, making a more expedite communication. The
superior performance will bring you full-new experience of a non-bottle-neck network.
TL-R4199G SMB Broadband Router makes plenty of applications become a reality. It can be
used for constructing intranet FTP, WEB, and Mail server, etc. Inaccessibly, it features network
game ports opened, MSN audio conversation and special application setting, providing much
more additional value to your network.
Featuring firewall and VPN Passthrough, the TL-R4199G SMB Broadband Router resists most
common Internet attacks and ensures secure data connectivity and transmission over the
Internet.
TL-R4199G SMB Broadband Router is easy-to-manage. Quick Setup is supported and friendly
help messages are provided for every step. So you can configure it quickly and share Internet
access, files and fun comfortably.
1.2 Features
¾Intel IXP core, main frequency up to 533Hz
¾Complies with IEEE 802.3, 802.3u , 802.3x, 802.1x standards
¾8 LAN ports, 1 WAN port
¾Support Port Bandwidth Control, Port Mirror, Port-based VLAN for LAN ports
¾Supports QoS based on IP address
¾Built-in NAT and DHCP server supporting static IP address distributing
¾Supports Virtual Server, Port Triggering, and DMZ host
¾Built-in firewall supporting IP address filtering, Domain Name filtering, and MAC address
filtering
¾Supports connecting/disconnecting Internet at a specified time of day
¾Supports access control, allowing parents and network administrators to establish restricted
access policies based on the time of day for children or staff
¾Supports TCP/IP, PPPoE, DHCP, ICMP, NAT, SNTP
¾Supports UPnP, Dynamic DNS, Static Routing, VPN pass-through
¾Supports Traffic Statistics
¾Supports ICMP-FLOOD, UDP-FLOOD, TCP-SYN-FLOOD filter
¾Ignores Ping packets from WAN or LAN ports

TL-R4199G SMB Broadband Router User Guide
2
¾Supports firmware upgrade
¾Supports Remote and Web management
Chapter 2.Hardware installation
2.1 Panel Layout
2.1.1 The Front Panel
The Router’s LEDs are located on the front panel (View from left to right).
Figure 2-1
LED Descriptions:
Name Status Indication
Not lit The router is power off
Power
Lit up The router is power on
Not lit The router works properly
M1 Lit up The router has a hardware error
Not lit The router has a hardware error
Lit up The router has a hardware error
M2
Flashing The router works properly
When M1 and M2 are flashing
synchronously, the router is
restoring the factory default
settings.
Not lit There is no device linked to the corresponding port
Lit up There is a device linked to the corresponding port but no activity
WAN/LAN
(Link/Act)
Flashing There is an active device linked to the corresponding port
Not lit The linked device is running at 10Mbps
100M(WAN)
Lit up The linked device is running at 100Mbps
Not lit The linked device is running at 10Mbps or 100Mbps
1000M(LAN)
Lit up The linked device is running at 1000Mbps
The front panel contains the following features. (Viewed from left to right)
¾Reset: Use the button to restore the router to the factory defaults.
There are two ways to reset the router:
Method one: Use the Factory Defaults function on System Tools -> Factory Defaults page in
the router's Web-based Utility.
Method two: Use the Factory Default Reset button. First, turn off the router's power. Second,
press the default reset button, then turn on the router's power, and hold the reset button until the
M1 and M2 LED flash simultaneously (about 3 seconds). At last, release the reset button and wait
for the router to reboot.

TL-R4199G SMB Broadband Router User Guide
3
)Note:
Ensure the router is powered on before it restarts completely.
¾WAN: One RJ45 port for connecting the router to a cable, DSL modem or Ethernet
¾LAN: Eight 10/100/1000Mbps RJ45 port for connecting the router to the local PCs
2.1.2 The Rear Panel
The rear panel of the TL-R4199G only features a power receptacle, which is an AC power
receptacle. Connect the female of the power cord head here, and the male head to the AC power
outlet.
Figure 2-2
2.2 System Requirements
¾Broadband Internet Access Service (DSL/Cable/Ethernet)
¾One DSL/Cable modem that has an RJ45 connector (It’s not necessary if you connect the
router to Ethernet)
¾Each PC on the LAN needs a working Ethernet Adapter and an Ethernet cable with RJ45
connectors
¾TCP/IP protocol must be installed on each PC
¾Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator 6.0 or later
2.3 Installation Environment Requirements
¾Not in direct sunlight or near a heater or heating vent
¾Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on all sides
of the router
¾Well ventilated (especially if it is in a closet)
¾Operating temperature: 0℃~40℃(32℉~104℉)
¾Operating Humidity: 10%~90%RH, Non-condensing
)Note:
Do not use this product near water, for example, in a wet basement or near a swimming pool.
Avoid using this product during an electrical storm. There may be a remote risk of electric shock
from lightning.
2.4 Connecting the Router
Before you install the router, you should connect your PC to the Internet through your broadband
service successfully. If there is any problem, please contact with your ISP for help. After that,
please install the router according to the following steps. Don't forget to pull out the power plug

TL-R4199G SMB Broadband Router User Guide
4
and keep your hands dry.
1. Power off your PC(s), Cable/DSL modem, and the router.
2. Connect the PC(s) and all Switches/Hubs on your LAN to the LAN Ports on the router, shown
in figure 2-3.
3. Connect the DSL/Cable modem to the WAN port on the router, shown in figure 2-3.
4. Connect the AC power adapter to the AC power socket on the router, and the other end into
an electrical outlet. The router will start to work automatically.
5. Power on your PC(s) and Cable/DSL modem.
Figure 2-3